Technical Setting, Event, Notification, To E-MAIL

6. TECHNICAL SETTING

Set PTZ & RS-485,EVENT, ALARM INPUT, MOTION ALARM OUTPUT and REMOTE CONTROL in TECHNICAL SETTING menu.

Press + buttons on remote controller to select PTZ in SETUP menu.

z PTZ ID	Select the PTZ ID. (0 ~ 99)
z PROTOCOL	Select the PROTOCOL. (Default is Pelco-D.)
z BAUD RATE	Select the BAUD RATE. (Default is 9600.)
	1200 → 2400 → 4800 → 9600 → 19200 →
	38400 → 57600 → 115200
	Baud rate means the speed of between the
	devices.
z DATA BIT	Select 5~8 the DATA BIT. (Default is 8.)
	Data bit means the number of data bit.
z STOP BIT	Select 1 or 2 the STOP BIT. (Default is 1.)
	Stop bit means the number of stop bit
	between data transfer.
z PARITY	Select the PARITY. (Default is No Parity.)
	No Parity → Odd Parity → Even Parity.
	Parity means the error check bit while the
	data is transferring.

NOTICE

All of settings must be the same as the PTZ camera’s settings.

The settings is different from the camera’s models. See the PTZ camera’s manual for setting of RS-485.

Press + buttons on remote controller to select EVENT in SETUP menu.

	z EVENT SERVER	Type the EVENT SERVER domain or IP address.
		Type the domain or IP address of the computer
		which used for operating CMS(Central Monitoring
		System) software.
2510		System) software.
		If you want to receive event message on CMS
2510

		software, you must set the same port as CMS port.
	z EVENT TYPE	Select the EVENT TYPE.
		The event occurrence at the time of which it selects
		to inform as the event server which it sets.
		It will be available to set the time when it will
		receive the event message in event type by.
	z EVENT	Check if you want to receive event message
	NOTIFICATION	by E-MAIL.
	TO E-MAIL	Must do SETUP after check.
	z MAIL SERVER	Type sender MAIL SERVER address.
		If you do not type mail server address,
		event message mail will be classified by spam.
	z USER ID & P/W	Type mail account USER ID and PASSWORD.

z MAIL ADDRESS Type the E-mail address to receive event message mail.

SETUP