JVC LPT1092-001A manual Angle Selection, Subtitle Selection Checking The Time Information

Page 49

ADVANCED PLAYBACK EN 49

Marking Positions To Play Back Again Later

8 Video CD/Audio CD

 

 

 

During playback

 

 

 

 

 

 

Current track elapsed time ] Current track remaining time ] Total

 

 

 

 

 

 

elapsed time ] Total remaining time ] (back to the beginning)

 

 

 

 

It is possible to mark positions (up to 999 points) where you want to play back once again later, and start playback from a marked position. Marking onto DVD-RAM/RW (VR mode only) discs when recording is helpful to locate a start point when you play back the discs later.

To mark positions:

During playback, press MARK at positions you want to mark.

●“MARK” appears on the TV screen. You can easily locate the marked positions using 2 or 6 when you play back the disc.

To delete the marked positions: While paused, press 2 or 6 to locate a marked position you want to delete, then press MARK.

●Crossed “MARK” appears on the TV screen, and the marked position is deleted.

NOTES:

●When a monaural or bilingual programme changes to a stereo programme while recording, a mark signal is automatically recorded.

●Titles will be divided into “chapters” at the marked points according to the disc types as follows:

DVD-R/RW (Video mode): After finalising, titles are divided into “chapters” at the marked points that are marked automatically approximately every 5 minutes during recording before finalising. ( pg. 90)

DVD-RW (VR mode): After finalising, titles are divided into “chapters” at the marked points that are marked at the desired locations during playback before finalising. ( pg. 90)

DVD-RAM: Titles are divided into “chapters” at the marked points that are marked at the desired locations during playback.

DVD VIDEO and finalised disc: Creating of marked points are not permitted.

In stop mode

0:00 ] Playback time of track 1 ] 0:00 ] Total length of a disc ] (back to the beginning)

NOTE:

When a PBC-compatible Video CD disc is loaded, deactivate the PBC function. ( pg. 50)

Angle Selection

You can enjoy a variety of scene angles if a DVD VIDEO disc contains “multi-angle” parts, where the same scene was shot from different angles.

If the disc contains “multi-angle” parts, “” appears on the TV screen at the beginning of the “multi-angle” part.

1Press ANGLE during playback.

The angle selection display

 

appears on the TV screen.

When 3 scene angles are

 

2 Press ANGLE or w e to select contained.

your desired angle.

 

●Each time you press ANGLE or w e, the angle changes.

●When “X” appears on the TV screen, the current scene is not recorded from multiple angles. In addition, some discs prohibit angle selection.

●To clear the angle selection display, press ENTER. In addition, the angle selection display disappears automatically if no operation is done for 10 seconds.

Subtitle Selection

Checking The Time Information

You can check time information of a disc on the front display panel and the TV screen.

Each press of DISPLAY changes the display as follows:

8DVD-RAM/DVD-R/DVD-RW During recording

Current title elapsed time ] Disc remaining time* ] Clock time (front display panel only) ] (back to the beginning)

* only discs before finalising

● Clock time is displayed only when a recordable disc is recorded.

During playback

Current title elapsed time ] Disc remaining time* ] Each title elapsed time ] (back to the beginning)

* only discs before finalising

In stop mode or during playback

●It is possible to check disc remaining time according to recording modes also by pressing REMAIN.

●In FR mode, it is possible to set recording time in detail. While the recording mode and the disc remaining time are displayed by pressing REMAIN, press rt to select “FR”, then press w e to select the desired recording time. ( pg. 62)

●It is not possible to switch the recording mode during playback or while recording.

Some DVD VIDEO discs contain more than one subtitle language, from among which you can choose the desired subtitle language. “” appears on the TV screen at the beginning of the part where more than one subtitle language are recorded.

1 Press SUBTITLE during

playback. The subtitle selection

ENGLISH

 

display appears on the TV screen.

When 3 subtitle languages are

● Each time you press SUBTITLE,

contained.

the subtitle display is switched on

 

and off.

 

2 Press w e to select your desired language.

●To clear the subtitle selection display, press ENTER.

NOTES:

●When “X” appears on the TV screen, no subtitle language is recorded.

●When the subtitle language won’t be changed with the procedure above, change the subtitle on a disc menu displayed by pressing MENU.

Page 48 Page 50
Image 49
Page 48 Page 50
Contents DR-MV5SE DR-MV5BE Mains outlet Safety PrecautionsDo not place the unit For ItalyDo not block the unit’s ventilation openings or holes To mobile phone usersEnjoy the vivid picture quality DVD recording/playback Enjoying your life withRecorder Recordable/Playable Discs About DiscsDiscs For Playback Only DVD-RAM DiscsUnplayable Discs Recording Medium And FormatFile Structure Of Discs Region NumberAudio CD/Video CD/Super Video CD Svcd DVD Video MarksJPEG/MP3 Disc CD-R/RW/ROM Marks related to videoCare And Handling Of Discs Placing a DiscRear View Front ViewHow To Use Remote Control pg On-Screen Display DVD deck On-Screen Display VHS deck C D EFG H I J K L M N Front Display PanelComposite Connection ConnectionsLuminance brightness Component Video Connection DVD deck only EN GET Over IT! ConnectionsSET UP Auto Set UpNumber Set VHS DVDClock Set/Auto Guide Program Number Set Preset DownloadLink Functions DVD Deck Only On The Front Display PanelVHS LanguageMonitor Set DVD Deck Only VHS DVD Enter SET UPPan&Scan/Letter Box Pan&ScanPlayback About recording modeWant to do? Load a disc Basic Playback DVDUsable cassettes Basic Playback VHSCompact VHS camcorder recordings can be played on this Load a recordable disc Basic Recording DVDMode Approx Time approx Recording ModeRecording Resume Function Recording Recording amountBasic Recording VHS Maximum Recording Use Mode Time ApproxClear VHS DVD Cancel Showview Timer Enter ReturnSatellite Receiver Users DVD Deck Only VPS/PDC Recording Weekly/Daily RecordingDVD Timer Manual Timer ProgrammingFor DVD deck To Make The Disc For On-Disc Timer Programming On-Disc Timer Programming DVD DeckOnly Satellite Receiver UsersHow Discs Are Overwritten To cancel the programme Check, Cancel And Change ProgrammesSAT RtweCancel Prog Enter When Programmes Overlap Each OtherPress Cancel To change the programme settingRecording DVD Deck Only REC ModeSAT Stop and pause mode on the DVD deck Auto Recording Mode OptimizerTo DVD Auto Title Creation DubbingVHS/DVD VHS Dubbing Dubbing a Part Of a CassetteDubbing An Entire Disc REC Mode Progressive ScanVHS/DVD Dubbing Dubbing a Part Of a Disc Enter REC Mode Progressive ScanPR + DV Dubbing DVD Deck Only Performing dubbing without using the DV Dubbing controllerEdit From a Camcorder If the camcorder has no S-VIDEO output connectorPanel When using your unit as the recording deck When using your unit as the source playerOutput/Input Set Output And L-1 Input SettingInput Setting Select SettingExample Dubbing to an MD Digital Audio DubbingHigh-Speed Search Advanced Playback DVDDVD TOP Menu Enter Still Picture/Frame-By-Frame Playback Resume FunctionSlow Motion Skip SearchSubtitle Selection Checking The Time Information Angle SelectionSelection display appears Audio Channel SelectionPress Audio or w e to select Your desired audio language SoundDisplay Recording/Playback Status DisplayRecording screen Overview Of Live Memory PlaybackDisplay During Live Memory Playback While Recording Available only when pausedTo Watch a Programme Previously Recorded While Recording Buttons To Be Used During Live Memory PlaybackHow To Access The On-screen Bar Using The On-screen BarBasic Operation On The On-screen Bar Enter NavigationEnter On Screen Clear Repeat PlaybackAdjusting The Picture Quality Setting The Progressive ModeTime Search If you have specified a wrong selectionSelect The Switching Interval Of The Slide Show Cancel EnterRandom Playback Programme PlaybackAdvanced Playback VHS Clean the video heads using a dry cleaning cassette whenQuick Rewind a Little Index SearchManual Tracking Next Function MemoryVHS Progressive Scan Soundtrack SelectionAdvanced Recording DVD Instant Timer Recording ITRElapsed Recording Time And Disc Remaining Time Indication DVD TV/VIDEOFree Rate Function Select FR Just in a recording mode selection procedureSelection Of The Audio Channel To Be Recorded On a Disc Elapsed Recording Time Indication Advanced Recording VHS0000 Accidental erasure preventionTo Record Stereo and Bilingual Programmes A2 Tape Remaining TimeTo Record Nicam Stereo and Bilingual Programmes PlaybackDisplay for original Display for play list Recording Library Database DVD NaviIcons and their meanings Modify Index Scan For Beginning Of TitleMemo Enter Navigation Modify Category Modify Title NameDelete Title Delete Unwanted Part Of The TitleAdd Scenes To a Play List Modify Play List InformationCreate Play List MemoSCENE, then press Enter Move ScenesDelete Play List Play Back Play ListModify Play List Name Press 8 to stop playbackScan For Title From Library Modify Library InformationRegister Disc Delete InformationFor MP3 Playback Locating The Desired Group And TracksFor Jpeg Playback On completion of the playback of all the itemsTips for your trouble Specifications Remote control settingFor better sound For DVD operations For VHS operations FormatRemote Control 1/2/3/4 Code Switching Remote Control FunctionsEnter SET UP For 4 to change the remote control code, then press EnterBrand Name Code TV Multi-Brand Remote ControlPin AV input Scart connector Has two 21-pin AV input Scart connectorsIN/DECODER connector to the satellite receiver’s connector Perfect Connections RecommendedWhen you can’t switch the audio channel of a bilingual Connecting/Using a Decoder DVD Deck OnlyProgramme Utility  pg Mode Set DVD DeckOthers  pg REC, then press EnterRecording SET PAL To record PAL signals Secam To record Secam signalsOFF You cannot use the resume function Scan Mode SetVHS Enter Mode Set VHS DeckThen press Enter Press rt to select the desired For Example Tray Lock DVD Deck OnlyTo lock tray To unlock trayGuide Program Number Set Showviewtm System SetupGuide Program Number Auto Channel Set Tuner SetPress rt to input the channel Press SET UP to close the Confirmation screenNumber you want to store Delete a Channel Press SET UP twice to close the Confirmation screenChange Station Channel Position Press rt w e to select the new channel position, then pressFine-Tuning Channels Already Stored When Receiving a Scrambled Broadcast DVD Deck OnlySet Stations a Set Stations BJust Clock Clock SetFormat a DVD-RAM Disc Format a Disc DVD Deck OnlyFormat a DVD-RW Disc Then press tFinalise a DVD-R/RW Disc After finalising For DVD-R/RW Video mode discsDVD Enter Initialising DVD Deck Only Playback DVD DeckGeneral Playback VHS Deck Timer Recording DVD DeckRecording DVD Deck Recording VHS DeckOther Problems Timer Recording VHS DeckFor composite connection For component video connectionAn invalid Showview number has been input.  pg Timer recording has finished during Live Memory playbackDuring Live Memory playback, 8 has been pressed.  pg Power consumption Power requirementTemperature Dimensions WxHxDLanguage Code List TV Station And ID List When Programmes Overlap Each Other Select The Switching Interval Of The Slide ShowAudio Language/Sound Selection Elapsed Recording Time IndicationMemo EN DR-MV5BE
Top Page Image Contents