JVC LPT1092-001A Power requirement, Power consumption, Temperature, Operating position, Format

Page 95

SPECIFICATIONS EN 95

GENERAL

Power requirement

AC 220 V – 240 Vd, 50/60 Hz

Power consumption

Power on: 38 W

Power off: 7.0 W

Temperature

Operating: 5°C to 35°C

Storage: –20°C to 60°C

Operating position

Horizontal only

Dimensions (WxHxD)

435 mm x 96 mm x 344 mm

Weight

5.8kg

Input/Output

Video input: 1.0 Vp-p, 75 C (pin jack)

Audio input:

–8 dB, 50 kC (pin jack)

Corresponding to mono (left) Audio output: –8 dB, 1 kC (pin jack)

21-pin SCART connectors: IN/OUT x 1, IN/DECODER x 1

Input/Output (DVD Deck Only) S-video input:

Y:1.0 Vp-p, 75 C

C:0.300 Vp-p, 75 C i.Link: 4-pin for DV input Component video output:

Y:1.0 Vp-p, 75 C

CB/CR, PB/PR: 0.7 Vp-p, 75 C Corresponding to copy protection

Digital audio output: Coaxial

Corresponding to Dolby Digital and DTS Digital Surround Bit stream

Selectable in digital audio output setting menu

VIDEO/AUDIO (DVD Deck)

Recording time

Maximum 8 hours (with 4.7 GB disc) (XP): Approx. 1 hour

(SP): Approx. 2 hours

(LP): Approx. 4 hours

(EP): Approx. 6 hours

(FR): Approx. 1 hour – 8 hours

Audio recording system

Dolby Digital (2 ch)

Linear PCM (XP mode only)

Video recording compression system

MPEG2 (CBR/VBR)

VIDEO/AUDIO (VHS Deck)

Signal system

PAL colour signal and CCIR monochrome signal, 625 lines/50 fields

Recording system

DA4 (Double Azimuth) head helical scan system

Format

VHS PAL standard

Maximum recording time

(SP): 180 min. with E-180 video cassette

(LP): 360 min. with E-180 video cassette

Signal-to-noise ratio

45 dB

Horizontal resolution

230lines

Frequency range

(Normal audio): 70 Hz to 10,000 Hz

(Hi-Fi audio): 20 Hz to 20,000 Hz

Specifications shown are for SP mode unless otherwise specified.

TUNER/TIMER

TV channel storage capacity 99 positions (+AUX position)

Tuning system

Frequency synthesizer tuner

Channel coverage VHF 47 MHz – 89 MHz/ 104 MHz – 300 MHz/ 302 MHz – 470 MHz UHF 470 MHz – 862 MHz

Memory backup time

Approx. 10 minutes

ACCESSORIES

Provided accessories

RF cable,

21-pin SCART cable, Infrared remote control unit, “R6” battery x 2

E.& O.E. Design and specifications subject to change without notice.

ATTENTION:

This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the unit off and unplug the AC power cord. Then plug it in again and turn the unit on. Take out the disc. After checking the disc, operate the unit as usual.

Image 95

Contents DR-MV5SE DR-MV5BE Mains outlet Safety PrecautionsTo mobile phone users For ItalyDo not place the unit Do not block the unit’s ventilation openings or holesEnjoy the vivid picture quality DVD recording/playback Enjoying your life withRecorder DVD-RAM Discs About DiscsRecordable/Playable Discs Discs For Playback OnlyRegion Number Recording Medium And FormatUnplayable Discs File Structure Of DiscsMarks related to video DVD Video MarksAudio CD/Video CD/Super Video CD Svcd JPEG/MP3 Disc CD-R/RW/ROMCare And Handling Of Discs Placing a DiscRear View Front View pg Remote ControlHow To Use On-Screen Display DVD deck On-Screen Display VHS deck C D EFG H I J K L M N Front Display PanelLuminance brightness ConnectionsComposite Connection Component Video Connection DVD deck only EN GET Over IT! ConnectionsVHS DVD Auto Set UpSET UP Number SetClock Set/Auto Guide Program Number Set Preset DownloadLink Functions DVD Deck Only On The Front Display PanelVHS LanguagePan&Scan VHS DVD Enter SET UPMonitor Set DVD Deck Only Pan&Scan/Letter BoxPlayback About recording modeWant to do? Load a disc Basic Playback DVDCompact VHS camcorder recordings can be played on this Basic Playback VHSUsable cassettes Load a recordable disc Basic Recording DVDRecording Recording amount Recording ModeMode Approx Time approx Recording Resume FunctionBasic Recording VHS Maximum Recording Use Mode Time ApproxSatellite Receiver Users DVD Deck Only VHS DVD Cancel Showview Timer Enter ReturnClear VPS/PDC Recording Weekly/Daily RecordingFor DVD deck Manual Timer ProgrammingDVD Timer Satellite Receiver Users On-Disc Timer Programming DVD DeckTo Make The Disc For On-Disc Timer Programming OnlyHow Discs Are Overwritten Rtwe Check, Cancel And Change ProgrammesTo cancel the programme SATTo change the programme setting When Programmes Overlap Each OtherCancel Prog Enter Press CancelSAT REC ModeRecording DVD Deck Only Auto Title Creation Dubbing Auto Recording Mode OptimizerStop and pause mode on the DVD deck To DVDVHS/DVD VHS Dubbing Dubbing a Part Of a CassetteVHS/DVD Dubbing REC Mode Progressive ScanDubbing An Entire Disc PR + Enter REC Mode Progressive ScanDubbing a Part Of a Disc DV Dubbing DVD Deck Only Performing dubbing without using the DV Dubbing controllerPanel If the camcorder has no S-VIDEO output connectorEdit From a Camcorder When using your unit as the recording deck When using your unit as the source playerOutput/Input Set Output And L-1 Input SettingInput Setting Select SettingExample Dubbing to an MD Digital Audio DubbingDVD TOP Menu Enter Advanced Playback DVDHigh-Speed Search Skip Search Resume FunctionStill Picture/Frame-By-Frame Playback Slow MotionSubtitle Selection Checking The Time Information Angle SelectionYour desired audio language Sound Audio Channel SelectionSelection display appears Press Audio or w e to selectDisplay Recording/Playback Status DisplayRecording screen Overview Of Live Memory PlaybackDisplay During Live Memory Playback Buttons To Be Used During Live Memory Playback Available only when pausedWhile Recording To Watch a Programme Previously Recorded While RecordingEnter Navigation Using The On-screen BarHow To Access The On-screen Bar Basic Operation On The On-screen BarEnter On Screen Clear Repeat PlaybackIf you have specified a wrong selection Setting The Progressive ModeAdjusting The Picture Quality Time SearchProgramme Playback Cancel EnterSelect The Switching Interval Of The Slide Show Random PlaybackIndex Search Clean the video heads using a dry cleaning cassette whenAdvanced Playback VHS Quick Rewind a LittleSoundtrack Selection Next Function MemoryManual Tracking VHS Progressive ScanDVD TV/VIDEO Instant Timer Recording ITRAdvanced Recording DVD Elapsed Recording Time And Disc Remaining Time IndicationSelection Of The Audio Channel To Be Recorded On a Disc Select FR Just in a recording mode selection procedureFree Rate Function Accidental erasure prevention Advanced Recording VHSElapsed Recording Time Indication 0000Playback Tape Remaining TimeTo Record Stereo and Bilingual Programmes A2 To Record Nicam Stereo and Bilingual ProgrammesIcons and their meanings Library Database DVD NaviDisplay for original Display for play list Recording Memo Enter Navigation Scan For Beginning Of TitleModify Index Delete Unwanted Part Of The Title Modify Title NameModify Category Delete TitleMemo Modify Play List InformationAdd Scenes To a Play List Create Play ListSCENE, then press Enter Move ScenesPress 8 to stop playback Play Back Play ListDelete Play List Modify Play List NameDelete Information Modify Library InformationScan For Title From Library Register DiscOn completion of the playback of all the items Locating The Desired Group And TracksFor MP3 Playback For Jpeg PlaybackFor DVD operations For VHS operations Format Remote control settingTips for your trouble Specifications For better soundFor 4 to change the remote control code, then press Enter Remote Control FunctionsRemote Control 1/2/3/4 Code Switching Enter SET UPBrand Name Code TV Multi-Brand Remote ControlPerfect Connections Recommended Has two 21-pin AV input Scart connectorsPin AV input Scart connector IN/DECODER connector to the satellite receiver’s connectorProgramme Connecting/Using a Decoder DVD Deck OnlyWhen you can’t switch the audio channel of a bilingual REC, then press Enter Mode Set DVD DeckUtility pg Others pgRecording SET PAL To record PAL signals Secam To record Secam signalsOFF You cannot use the resume function Scan Mode SetThen press Enter Press rt to select the desired Mode Set VHS DeckVHS Enter To unlock tray Tray Lock DVD Deck OnlyFor Example To lock trayGuide Program Number Showviewtm System SetupGuide Program Number Set Auto Channel Set Tuner SetNumber you want to store Press SET UP to close the Confirmation screenPress rt to input the channel Press rt w e to select the new channel position, then press Press SET UP twice to close the Confirmation screenDelete a Channel Change Station Channel PositionSet Stations B When Receiving a Scrambled Broadcast DVD Deck OnlyFine-Tuning Channels Already Stored Set Stations aJust Clock Clock SetThen press t Format a Disc DVD Deck OnlyFormat a DVD-RAM Disc Format a DVD-RW DiscDVD Enter After finalising For DVD-R/RW Video mode discsFinalise a DVD-R/RW Disc General Playback DVD DeckInitialising DVD Deck Only Recording VHS Deck Timer Recording DVD DeckPlayback VHS Deck Recording DVD DeckFor component video connection Timer Recording VHS DeckOther Problems For composite connectionDuring Live Memory playback, 8 has been pressed. pg Timer recording has finished during Live Memory playbackAn invalid Showview number has been input. pg Dimensions WxHxD Power requirementPower consumption TemperatureLanguage Code List TV Station And ID List Elapsed Recording Time Indication Select The Switching Interval Of The Slide ShowWhen Programmes Overlap Each Other Audio Language/Sound SelectionMemo EN DR-MV5BE