Sima Products SUR-47 user manual Learning from Another Remote Control

Page 18

Getting Started

SUR-47 User’s Manual

Learning from Another Remote Control

Before using learning mode, set both remotes on a flat surface so that the device’s remote control IR is pointed at the SUR-47’s learning eye, which is located at the bottom of the unit.

1.Press or to select LEARN.

2.Press .

3.Point the target device's remote control at the SUR-47 learning eye located at the base of the unit (see Figure 1A: SUR-47 Front View).

4.Press the button corresponding to the target device.

The SUR-47 Touch Screen sequentially displays screens corresponding to first the hard keys, then page one of the soft keys, and finally page two of the soft keys. The blinking rectangle denotes the key being learned.

5.Press the corresponding button of the target device's remote control.

The SUR-47 screen displays an OK message if the code was successfully learned or an ERROR message if the code was not learned.

Press PAGE to toggle between hard and soft key displays.

Note: When the remote has learned the last button on the page, the next page is automatically displayed.

6.Press EXIT to exit learning mode.

14

Image 18
Contents SUR-47 Preface SUR-47 User’s Manual Table Of Contents Table of Contents Table of Contents SUR-47 User’s Manual SUR-47 Features Introducing the SUR-47Unpacking the SUR-47 Identifying Components SUR-47 Front ViewSUR-BU Rear View Installing Batteries Installing The Base UnitUsing the IR blaster cable Battery IndicatorAbout the Touch Screen Battery Tips and PrecautionsTouch Screen Precautions Turning the Touch Screen OnUsing Hard Keys Entering the Setup MenusNavigating the Setup Menus Setup menu tree Setup Menu HierarchySetting Up the SUR-47 Device MenuCreating a New Device Setting the RF Address Re-Labeling DevicesCode Menu Deleting DevicesUsing Pre-Code to Program Devices Manually Selecting the CodeUsing the Learning Mode Before Using the Learning FunctionLearning from Another Remote Control Erasing Key Codes Erasing Device Codes Debugging Device Codes Using Macros LCD LayoutCreating a New Macro Deleting a Macro Setting Channels Viewing a MacroAdding a Quick Channel Deleting a Quick Channel Relabeling a Quick ChannelUsing the Transmission Feature Miscellaneous MenusSetting the Date and Time Setting the Power Down Time Setting the Backlight On TimeSetting the Beep Signal Checking the Version NumberResetting the SUR-47 to Factory Defaults Controlling Devices Selecting a Device to ControlAlternating Touch Screen Pages Viewing the Macro Key Using the Quick Channel Buttons Using the AUX Key Controlling DevicesAppendix a Specifications Appendix B Accessories PC Interface Kit SUR-PCAppendix C Troubleshooting Troubleshooting TablesTrouble Shooting SUR-47 User’s Manual SUR-47 User’s Manual Trouble Shooting