Fig. 1B IR Out jack – Connect the IR blaster cable to this jack to operate a specific device.
Base Unit address setting – Set the RF address of the base unit by selecting an address number between 0 and 9.
AC adapter input – Plug AC adapter into jack.
Fig. 1C Remote Locator Button – Press to trigger beep signal and locate remote.
Infrared Emitter– Sends IR signal, aim at equipment
Fig. 1D IR Blaster Cable – Attach directly to equipment that is not within directional range of base unit. With front and rear adhesive.
Fig. 1E AC Adapter – Plug into base unit and into 120V AC outlet.
Introduction
IR Out jack
Base Unit address setting
AC adapter input
Figure1B: SUR-BU Rear View
Remote Locator
Button
Infrared
Emitter
Figure 1C: SUR-BU front view
Figure 1D: IR Blaster cable | Figure 1E: AC adapter |
with front and rear adhesive |
|
3