SUR-47 User’s Manual | Specifications |
Debugging Device Codes
Use this procedure if the SUR-47 is unable to recognize the infrared signals from another remote control. Once you have collected unrecognizable codes, you can use the optional SUR-PC link cable (see
Appendix B - Accessories on page 34 for more info) to upload them to your personal computer and then email them to Sima Products for analysis.
The email address is info@simacorp.com
Every time you enter DEBUG mode, the SUR-47 replaces previously stored unrecognized codes with new ones. If you have more than one remote that is not programmable, upload the first remote’s unrecognized codes and then gather the second remote's unrecognized codes.
Set up the LCD display before using this function. See LCD Layout on page 18.
1.Press 
or 
to select DEBUG.
2.Press 
.
3.Point the target device's remote control at the SUR-47 learning eye located at the bottom of the unit (see Figure 1A: SUR-47 Front View).
4.Select a device (for example TV).
The SUR-47 Touch Screen sequentially displays screens corresponding to first the hard keys, then page one of the soft keys, and finally page two of the soft keys. The blinking rectangle denotes the key being learned.
5.Press the corresponding button of the target device's remote control.
The SUR-47 screen displays an OK message if the code was successfully learned.
Press PAGE 
to toggle between hard key and soft key displays.
6.Press YES 
or EXIT 
to exit debug mode.
