Sima Products SUR-47 user manual Re-Labeling Devices, Setting the RF Address

Page 14

Getting Started

SUR-47 User’s Manual

Re-Labeling Devices

Follow these instructions to edit a device label.

1.Press or to select RELABEL.

2.Press .

3.Press the device key you want to relabel (for example TV).

4.Edit the device label:

Press or to scroll through the characters (from A-Z, 0-9, and the space key).

Note: Press and hold or to quickly scroll through the characters.

Press or to move to the previous or next character. When selected, the character blinks.

Press to confirm the entry.

5.Press Exit to exit to the device menu.

Setting the RF Address

Each device button (TV, VCR, DVD etc.) can be set to operate on either IR or RF frequencies. When transmitting an IR signal the SUR-47 will operate the selected device by directly sending IR signals to the device. To operate in this mode, you must point the SUR-47 at the desired device.

To operate in the RF mode, the SUR-47 transmits an RF frequency signal to the SUR-BU base unit, which sends an IR signal to the desired device. Both the device and the base unit must be set to the same RF address to operate properly. To set the RF address:

1.Press or to select ADDR

2.Press OK

3.Select either IR to operate in the IR mode or an RF address (0-9) for the base unit and device

4.If an RF address is selected, set the base unit to the same RF address by adjusting the ADDRESS wheel on the rear panel as needed.

10

Image 14
Contents SUR-47 Preface SUR-47 User’s Manual Table Of Contents Table of Contents Table of Contents SUR-47 User’s Manual Unpacking the SUR-47 SUR-47 FeaturesIntroducing the SUR-47 Identifying Components SUR-47 Front ViewSUR-BU Rear View Installing Batteries Installing The Base UnitUsing the IR blaster cable Battery IndicatorAbout the Touch Screen Battery Tips and PrecautionsTouch Screen Precautions Turning the Touch Screen OnNavigating the Setup Menus Using Hard KeysEntering the Setup Menus Setup menu tree Setup Menu HierarchySetting Up the SUR-47 Device MenuCreating a New Device Setting the RF Address Re-Labeling DevicesCode Menu Deleting DevicesUsing Pre-Code to Program Devices Manually Selecting the CodeUsing the Learning Mode Before Using the Learning FunctionLearning from Another Remote Control Erasing Key Codes Erasing Device Codes Debugging Device Codes Using Macros LCD LayoutCreating a New Macro Deleting a Macro Setting Channels Viewing a MacroAdding a Quick Channel Deleting a Quick Channel Relabeling a Quick ChannelUsing the Transmission Feature Miscellaneous MenusSetting the Date and Time Setting the Power Down Time Setting the Backlight On TimeSetting the Beep Signal Checking the Version NumberResetting the SUR-47 to Factory Defaults Alternating Touch Screen Pages Controlling DevicesSelecting a Device to Control Viewing the Macro Key Using the Quick Channel Buttons Using the AUX Key Controlling DevicesAppendix a Specifications Appendix B Accessories PC Interface Kit SUR-PCAppendix C Troubleshooting Troubleshooting TablesTrouble Shooting SUR-47 User’s Manual SUR-47 User’s Manual Trouble Shooting