Honeywell XYR 5000 LINE manual Terminal Block Labels

Page 15

Figure 3-2 Overall Wiring Schematic

Warning! Explosions may result in death or serious injury. Do not remove the instrument cover in explosive atmospheres when power and/or communications are on.

To begin the electrical installation first remove the explosion proof housing cover from the Base Radio, if you have not already done so. Point the Base Radio antenna away from you and look at the green PC Board found directly underneath the NEXT and ENTER buttons. You should see two terminal blocks and some labels as shown in Figure 3-3.

Figure 3-3 Terminal Block Labels

8

Image 15

Contents XYR 5000 Line 34-XY-25-05 Rev 08/06 Base Radio User GuidePage FCC Certification Base RadioRevision Notes ContactsTelephone Table of Contents Quare R OOT F Unction Table of Figures Overall Wiring SchematicUsing this Manual IntroductionAbout the Device Software Compatibility UnpackingQuick Start Overall Wiring SchematicPage Installation Mechanical InstallationBase Radio Positioning General Layout Electrical Specifications Electrical InstallationTerminal Block Labels Wiring RS-485 to the Base Radio Wiring Power to the Base RadioWiring RS-485 to the Base Radio Wiring the RS-485/232 Converter to the Base RadioUSB Driver Installation Wiring the RS-485/USB Converter to the Base RadioUSB Driver Un-installation Daisy-Chaining Multiple Base Radios to Single RS-485/PowerWiring the DB-9 RS-485 Cable to the Base Radio USB Converter’s Male DB-9 ConnectorDaisy-Chaining RS-485 to Multiple Base Radios Daisy-Chaining Power to Multiple Base RadiosDaisy-Chaining RS-485 to Multiple Base Radios Terminating Communications Wiring to the Base RadioHigh Gain Antenna Grounding the Base RadioGeneral Configuration Base Radio Displayed MessagesRead Only Sequence Read Only Sequence Overall Configuration Menu MapMenu Map to Password Setting Setting the User PasswordRF Channel Selection Configuring the RF CommunicationsRF Baud Rate Selection Menu Map to RF Baud Rate SettingHigh Rfid Setting High RF ID SettingModbus Baud Rate Setting Base Radio SetupMenu Map to Modbus Baud Rate Setting Modbus Device ID SettingPage Modbus Mapping Mode Setting Modbus Parity SettingRegmode Modbus Communication ProtocolModbus Commands Command 03-Read Holding RegistersCommand 08- Diagnostic Command 11- Get Com Event Counter Command 12- Get Com Event LogCommand 17- Report Slave ID Register Address Description Command 43- Read Device IDBase Radio Holding Registers Register Address Description Register TypeValue Base Radio Device Status Base Radio Device Type RegistersBase Radio Device Status Registers Base Radio On/Offline Transmitter RegistersRegister Address Device ID Mapping ModeRegister Mapping Mode Transmitter Holding RegistersValue Device Type Transmitter Device Type Holding RegistersValue Transmitter Device Status Alarm Condition WN571 onlySquare Root Function Transmitter Device Status RegistersTechnical Specifications Overall Base Radio Dimensions Appendix a Navigating the Menus Figure A- 1 Base Radio Menu Map Appendix B Base Radio Menu MapAppendix C Modbus Register Definitions Page Page Page Honeywell