Honeywell XYR 5000 LINE manual Table of Contents

Table of Contents

TABLE OF CONTENTS		V
TABLE OF FIGURES		VII
1 INTRODUCTION		1
1.1	USING THIS MANUAL	1
1.2	ABOUT THE DEVICE	1
1.3	UNPACKING	2
1.4	SOFTWARE COMPATIBILITY	2

2	QUICK START		3
3	INSTALLATION		5
	3.1	MECHANICAL INSTALLATION	5
		3.1.1 Base Radio Positioning	5
	3.2	ELECTRICAL INSTALLATION	7
		3.2.1 Electrical Specifications	7
		3.2.2 Wiring Power to the Base Radio	9
		3.2.3 Wiring RS-485 to the Base Radio	9
		3.2.4 Wiring the RS-485/232 Converter to the Base Radio	10
		3.2.5 Wiring the RS-485/USB Converter to the Base
		Radio	11
		3.2.6 Daisy-Chaining Multiple Base Radios to Single RS-
		485/Power	12
		3.2.7 Terminating Communications Wiring to the Base
		Radio	14
		3.2.8 Grounding the Base Radio	15
		3.2.9 High Gain Antenna	15

4 GENERAL CONFIGURATION		16
4.1	BASE RADIO DISPLAYED MESSAGES	16
	4.1.1 The Read Only Sequence	16
4.2	OVERALL CONFIGURATION MENU MAP	17
4.3	SETTING THE USER PASSWORD	18

5 CONFIGURING THE RF COMMUNICATIONS		19
5.1	RF CHANNEL SELECTION	19
5.2	RF BAUD RATE SELECTION	20
5.3	HIGH RF ID SETTING	21

6 CONFIGURING THE MODBUS COMMUNICATIONS		22
6.1	BASE RADIO SETUP	22
	6.1.1 Modbus Baud Rate Setting	22
	6.1.2 Modbus Device ID Setting	23
	6.1.3 Modbus Parity Setting	25
	6.1.4 Modbus Mapping Mode Setting	25
6.2	MODBUS COMMUNICATION PROTOCOL	26
6.3	MODBUS COMMANDS	27
	6.3.1 Command 03-Read Holding Registers	27
	6.3.2 Command 08- Diagnostic	27
	6.3.3 Command 11- Get Com Event Counter	28
	6.3.4 Command 12- Get Com Event Log	28
	6.3.5 Command 17- Report Slave ID	28

V