Honeywell XYR 5000 LINE manual Appendix a Navigating the Menus

Page 43

Appendix A Navigating the Menus

Pressing either the NEXT or ENTER buttons located on the front of the Transmitter or Base Radio just below the Liquid Crystal Display (LCD) screen is all that is needed to navigate the respective menus. Pressing both of these buttons for one second will turn the unit on.

Pressing the NEXT button at any time while the Base Radio is cycling through the normal messages causes the Base Radio to enter the setup mode. The NEXT button is then used to step through menu options, and the ENTER button is used to enter a submenu of what is displayed on the LCD at that time. If no button is pressed within a 30 second period the unit goes back to the normal display mode.

If you enter a submenu that requires a numerical input, such as 001, the leftmost 0 will be blinking. This indicates that pressing the NEXT button will increment this value with each press from 0 to 9 and back to 0 again. Pressing the ENTER button will move to the next available value. If the last value is blinking, pressing ENTER will save the entered values and return to the return from the sub menu.

36

Image 43

Contents XYR 5000 Line 34-XY-25-05 Rev 08/06 Base Radio User GuidePage FCC Certification Base RadioContacts Revision NotesTelephone Table of Contents Quare R OOT F Unction Table of Figures Overall Wiring SchematicIntroduction Using this ManualAbout the Device Software Compatibility UnpackingQuick Start Overall Wiring SchematicPage Mechanical Installation InstallationBase Radio Positioning General Layout Electrical Specifications Electrical InstallationTerminal Block Labels Wiring RS-485 to the Base Radio Wiring Power to the Base RadioWiring RS-485 to the Base Radio Wiring the RS-485/232 Converter to the Base RadioUSB Driver Installation Wiring the RS-485/USB Converter to the Base RadioUSB Driver Un-installation Daisy-Chaining Multiple Base Radios to Single RS-485/PowerWiring the DB-9 RS-485 Cable to the Base Radio USB Converter’s Male DB-9 ConnectorDaisy-Chaining RS-485 to Multiple Base Radios Daisy-Chaining Power to Multiple Base RadiosDaisy-Chaining RS-485 to Multiple Base Radios Terminating Communications Wiring to the Base RadioHigh Gain Antenna Grounding the Base RadioBase Radio Displayed Messages General ConfigurationRead Only Sequence Read Only Sequence Overall Configuration Menu MapMenu Map to Password Setting Setting the User PasswordRF Channel Selection Configuring the RF CommunicationsRF Baud Rate Selection Menu Map to RF Baud Rate SettingHigh Rfid Setting High RF ID SettingModbus Baud Rate Setting Base Radio SetupMenu Map to Modbus Baud Rate Setting Modbus Device ID SettingPage Modbus Mapping Mode Setting Modbus Parity SettingRegmode Modbus Communication ProtocolCommand 03-Read Holding Registers Modbus CommandsCommand 08- Diagnostic Command 12- Get Com Event Log Command 11- Get Com Event CounterCommand 17- Report Slave ID Register Address Description Command 43- Read Device IDBase Radio Holding Registers Register Address Description Register TypeValue Base Radio Device Status Base Radio Device Type RegistersBase Radio Device Status Registers Base Radio On/Offline Transmitter RegistersRegister Address Device ID Mapping ModeRegister Mapping Mode Transmitter Holding RegistersValue Device Type Transmitter Device Type Holding RegistersValue Transmitter Device Status Alarm Condition WN571 onlySquare Root Function Transmitter Device Status RegistersTechnical Specifications Overall Base Radio Dimensions Appendix a Navigating the Menus Figure A- 1 Base Radio Menu Map Appendix B Base Radio Menu MapAppendix C Modbus Register Definitions Page Page Page Honeywell