Remote Control Settings
Remote Control Settings
Change the Address
The remote control and receiver can operate on any one of 16 addresses; however, they must both be on the same address for the remote to control the receiver. This section explains how to change the address in both devices.
Note: Do not change the address of the remote unless absolutely necessary because the remote cannot control the receiver if the two devices have different addresses.
1.Press SYS INFO button on your remote control. The System Information screen displays and shows the Remote Address.
Write down this address: _____________
2. Press and hold the SAT button on your remote control for about three seconds, until all of the mode buttons light up, and then let go of the SAT button.
3.Use the NUMBER PAD buttons to enter any num- ber between 1 and 16, but not the one you wrote in step 1.
Write down the number you entered:___________
4.Press the POUND (#) button. If you entered the address correctly, the SAT mode will flash three times.
5.Press the RECORD button.
Note: Make sure the Remote Address you see on the System Information screen is the same as the one you entered in step 3. If it isn't, the remote cannot control the receiver.
6.Press the SELECT button to close the System Information screen.
Checking the Remote Control Address
1. Press and hold the SAT mode button for three seconds, until all of the mode buttons light up, and then let go of the SAT button.
2.Press the POUND (#) button twice. The SAT mode button will flash the same number of times as the address number (for example: three flashes means address 3).
Page 13