Kathrein UFD 420 manual Selecting a programme, Adjusting volume, balance and tone

Receiver operation

Selecting a programme

∙Use the numeric keys ... to select the desired programme directly.

Example for a three-digit entry (“free” entry – see initial setting):):

Selection of programme slot 147

∙1 is entered, programme slot 1 appears

∙4 is entered, programme slot 14 appears

∙7 is entered, programme slot 147 now appears.

	or
	∙ Use the	keys to step through the programmes in succession.
	After the programme changeover, the programme slot and programme name are
	superimposed on the screen for approximately three seconds.
Note	With the setting “2- or 3-digit programme selection“ there is a switch to the desired
	programme after approximately 3 seconds. Further digits can be entered during
	this time.

With the setting “free entry“ (in the above example) the receiver switches to the corresponding programme slot immediately after each input.

Adjusting volume, balance and tone

The unit is in normal mode (TV or radio mode).

∙Use the (volume) keys to adjust the volume to the desired level.

The volume is adjustable in 21 steps. The volume level set appears on the LED display for approximately 3 seconds. At the same time a bar indicator appears on the screen.

Note	The settings are not operative on the VCR Scart socket in order not to disturb any
	recordings..
	The on-screen display is removed again after approximately 3 seconds..
	Whilst the menu for volume adjustment is overlaid, the	key can be used to acti-
	vate the following menu for balance adjustment, tone adjustment, stereo width and
	pseudo-stereo.

	Using the	keys or the	key you can select the particular menu entry and
	then make changes with the		keys.
Note	In the menu entry “Stereo Width" the stereo base width can be adjusted independ-
	ently.

11