Initial settings
When making the setting, it should be ensured that there is at least one blank channel above and below the output channel in order to avoid interference.
Modulator TV / VCR
Here you can assign the UHF modulator to either the TV- or the VCR Scart socket.
Factory presetting: assignment to the TV Scart socket.
An assignment to the VCR Scart socket is recommended if, for example, your video recorder is unsuitable for “VPS“ via the Scart input. In this case, connect the video recorder via the UHF modulator and assign the modulator to the VCR Scart socket.
OSD language
Here you can select the language for the
Default: German
LNB supply voltage
Here you can turn off the power supply for the feed system if this is implemented by an external power supply and signal selection is likewise not carried out by means of the LNB supply voltage (e.g. Kathrein
Note | If there are switchover matrices in the receiving system, the LNB supply voltage |
| needs to be turned in all cases. |
| Default: ON |
LNB supply voltage in standby
When the receiver is in standby the LNB supply voltage is normally switched off. If terrestrial signals and satellite signals are combined in the receiving system, and the power supply for the relevant components comes from the receiver, the power supply must also be guaranteed when the receiver is in standby.
In this case switch the power supply in standby to “On“.
Default: “Off“.
Programme selection
You have the option of entering the programme number in
| Default: “free“. |
|
|
| Setting |
| Settable programme slots |
|
| ||
|
|
|
|
|
| Programme slots 1 to 9 | |
|
| Programme slots 1 to 99 | |
|
| Programme slots 1 to 250 | |
| Free input |
| Programme slots 1 to 250 |
|
|
|
|
Note | If a recording is | ||
| must be cleared first in order that a change in the programme slot entry can be car- | ||
| ried out. |
|
|
On Screen Displays (OSD)
Here you can select whether the programme slot and programme name are to be
25