Kathrein UFD 420 manual Safety instructions, Important notes regarding operation

Page 5

Safety instructions

The following section contains important information relating to operation, place of installation and connecting-up of the receiver.

Read these notes carefully before putting the unit into operation.

Important notes regarding operation

Extended absence / Thunderstorms

Always switch the unit off via its mains switch during periods of extended absence or at the onset of thunderstorms. This also applies to any other equipment atta- ched.

However, take account of any possible timer programming, and switch the unit on again in good time prior to the recording time.

Mains lead

Make certain that the mains lead (power supply lead) is undamaged. Never put the unit into operation if the mains lead is damaged.

Cleaning

Withdraw the mains plug before cleaning the unit. Use a dry cloth for cleaning.

Children-at-play

Pay attention that children do not insert objects into the ventilation slots. There is a risk of mortal danger due to electric shock.

Repairs

On no account remove the housing cover since there are dangerous voltages in- side the unit that may be contacted. The unit must only be opened by qualified specialists, so allow them to carry out any repairs or adjustments to your receiver. Unauthorised opening entails loss of guarantee.

The electrical safety of the unit can be affected by improper tampering with it.

The manufacturer‘s liability excludes accidents occurring to the user when the unit is opened.

5

Image 5
Contents Kathrein Satellite Receiver UFD Contents Controls, displays and connections Rear panel controls and displays Remote control handset keysFront panel controls and displays Important notes regarding operation Safety instructionsImportant notes for siting and installation Connecting up the unit Connecting up and putting into operationSatellite signal connection Receiving system presetsUHF connection Inserting batteries into remote control handsetAudio connection Decoder connectionSelect the OSD in English is described on pages 24 External infrared sensorSwitchover between TV and radio mode Switching the unit onReceiver operation Twin-receiver fundamentalsSelecting a programme Adjusting volume, balance and toneMuting the sound Setting date and timeStereo- / Mono- / Channel changeover SAT/TV changeoverMaking the settings Timer settingSaving settings and starting the clock Return to receive modeSaving settings Making settingsMeaning of the columns Making changesVideo recorder playback VCR Daily and weekly repeated switch-onSwitching back to last programme swapping Example Operation without remote controlProgramme sorting inserting, swapping and copying Info menu Displaying programme overviewStop-watch Programming TV programmes Tuning in TV programmesPolarisation/Oscillator Video menuDescription of menu entries Satellite frequency Video deviation Decoder menuOrbit Position Programme name Audio modeAudio menu Audio carrier frequencySaving the settings Volume offsetAudio de-emphasis for sound type Mono wide only Stereo, Mono narrow Dnr , 75 μs Mono wide 50 μs or J17Radio menu Tuning in radio programmesProgramming radio programmes Modulator output channel Initial settingsCalling the initial setup menu OSD language Modulator TV / VCRLNB supply voltage LNB supply voltage in standbyOscillator frequency LED brightnessChanging the oscillator frequency DiSEqC menuTone-burst and DiSEqC-signal KHz signalSetting options in the DiSEqC menu Factory presetDiSEqC Tone burstDiSEqC repeat UFO miniUFO micro Features Specifications Accessories Temperature rangeScart socket designations GeneralESC Connection example935.2075/E/1/05.99/SKS/PF Subject to alterations