Programming TV programmes
∙Select the desired menu line using the keys 
.
∙For direct numeric input use the keys 
...
or
∙Alter the values 
keys.
∙Press the 
key twice in order to save your settings.
∙Exit from the menu using the 
key.
The settings are applicable for the TV- and VCR branch.
Note | Frequent reference is made to saving the settings in subsequent descriptions. It is |
| always sufficient, however, if you save the settings in the video and audio menus |
| just once before exiting from the programme slot or before exiting from setup |
| mode. |
The "Video" menu
The following settings can be made in the video menu:
Setting option: |
|
Programme slot: | 1 to 250 |
Programme name: | |
from 10700...12747 MHz | |
Polarisation: | Hor Low / Vert Low / |
| Hor High / Vert High |
Orbit position: | 1 to 4 |
Video deviation: | 16 or 25 MHz |
Oscillator groups: | LO 1 to LO 4 |
Decoder menu: | See separate decoder menu |
The bottom line shows the keys you can use to make the settings.
Description of menu entries
Satellite frequency
With input via the numeric keys 
...
frequency input is in
range 10700 to 12747 MHz. With the 
keys you can attain the optimum receiv- ing frequency by moving in 1 MHz steps (recommended if the picture is grainy due to weak signals).
Polarisation/Oscillator
In menu entry “Polarisation“, the voltage level is used (14 or 18V) to set the polarity (vertical or horizontal).
In the “Oscillator" menu entry, the oscillator frequency group LO 1 to LO4 is se- lected. With the oscillator frequency the high satellite frequency is converted to the satellite IF frequency. This allows troublefree matching to different feed systems.
Frequency range
Polarisation LNB- voltage
Setting
LO- group
LO- frequency
10.70– 11.70 GHz
10.70– 11.70 GHz
11.70– 12.75 GHz
11.70– 12.75 GHz
horizontal vertical horizontal vertical
18V
14V
18V
14V
Hor. Low
Vert Low
Hor. High
Vert High
LO 1 LO 2 LO 3 LO 4
9750 MHz
9750 MHz
10600 MHz
10600 MHz
For setting of LO frequencies refer to section: “Initial setting".
19