Controls, displays and connections
Front panel controls and displays
1Mains switch (with mains isolation)
2LED display for TV (four character
tuner A. Tuner A is assigned to the TV Scart socket. This display is also used to show the setup parameters in the setup mode.
3LED display for VCR (four character
tuner B. Tuner B is assigned to the VCR Scart socket.
4Buttons for programme selection
Step-by-step programme selection (upwards and down- wards).
Switchover from TV to radio mode, and switchover from tuner A to B by pressing both buttons simultaneously.
Rear panel controls and displays
1Mains input socket for 230 V/50 Hz.
Remote control handset keys
Function 1:
To change over the selecting of programmes from tuner A to tuner B and
Function 2:
To blank out the video signal (in setup mode) This function is to be used if the picture no longer syn- chronises on adjustment and the picture scrolls.
Function 1:
Last function. Allows you to switch back to the last programme that was selected
Function 2:
Displays the info menu
(active only if after pressing the key the programme list is displayed.)
Function 1:
Calls up the TV programme list (or radio programme list in radio mode).
Function 2:
Calls up menu for "Programme slot sorting (insertion), swapping and copying“
(with | press in succession) |
Function 1:
Volume control
Function 2:
To alter settings data in setup mode
Function 1:
Stores the chosen settings
Function 2:
Primary key for calling the separate setup menus (e.g. video settings)
Function 1:
Mutes the sound
Function 2:
Calls up the menu for audio settings
(with | press in succession) |
2DATA socket
a)Connection facility for the URS 200 external infrared sensor
b)Connection for the UFP 10
3VHF/UHF antenna input (signal is looped through).
4VHF/UHF antenna output
(TV signal
5Satellite IF signal input A and output of LNB supply voltage.
6Audio output, left and right channel (Cinch sockets).
7Scart socket, TV connection
8Scart socket, VCR connection
9Scart socket, decoder connection
10Satellite IF signal input B and output of LNB supply voltage.
Starts a timer
Last function. Allows you to switch back to the last pro- gramme that was selected
Function 1:
On/Off (Standby),
Attention: No mains isolation results!
Function 2:
Return from setup mode into normal operation
Set timer, date and time
Function 1:
Selection of TV/SAT mode
Function 2:
Call up the menu for video settings
(with | press in succession) |
Function 1:
Step through the programmes either up or down
Function 2:
Selection of individual menu entries in setup mode
Function 1:
Switchover to radio mode
Function 2:
Calls up the menu for radio settings
(with | press in succession |
| Stereo/Mono- (2 channel) changeover |
| Numeric keys 0 - 9 for programme selection and fre- |
to | quency entries |
|
4