Switching On for the First Time
The first steps
•Make sure that you have made all connections correctly.
•Connect the receiver to the mains power supply.
•Switch on the receiver by pressing the power button at the front of the unit.
The operation indicator LED on the front panel lights red, the receiver is now in standby mode.
Switch on the receiver by pressing the button on the remote control.
• The green LED lights and the receiver assumes reception mode.
The green LED at the front of the receiver provides confirmation every time a button is pressed on the remote control.
You will see the factory preset channel on your TV screen. An information bar indicating the channel provider, the time, the timer settings, the channel status and the channel title will be displayed in the bottom section of the screen provided the corresponding data are transmitted. The number of the channel memory appears in the LED display.
The red standby indicator goes out.
You can now receive the TV and radio channels preset at the factory and select them by pressing the buttons. Press the
and buttons to select radio channels. Press the or button to return to TV channels.
Refer to the section "Channel lists – TV/radio" for information on how to set up and save other TV and radio channels.
The reception status last set always reappears when the receiver is switched on.
If the message "bad or no signal" appears on the screen in addition to an
Factory setting of the receiver
Before you change the basic settings of your receiver, make a note of the settings in the form provided at the end of this User's Guide. In this way, you will be able to restore the original settings at any time.
15