Switching On for the First Time
Switching on with BZD 30
1.Switch on the TV set and the receiver.
-Switch the receiver into the operating mode with the
2.Switch the TV set to AV mode if the TV set does not switch over by itself.
3.To activate the power supply for the antenna, please perform the following steps with the receiver remote control:
-Press the button to reach the main menu.
-When you are in the main menu please select the "Installation"
button
-Now go with the buttons to "Network Configuration“ and again confirm with .
-Press the button once again to reach the "Power" subitem.
-Under this item you must now change the selection of the supply voltage with the buttons from "Off" to "On" (see figure).
-The antenna is now supplied with the operating voltage of 5 V.
-You return to the TV mode by pressing four times.
16