Remote Control Command Set
| The remote control features 2 command sets, making it possible to |
| operate 2 receivers independently of each other in one room (not |
| together with a twin receiver). |
Note: | For this purpose, program one receiver on the command set 1 and the |
| second receiver on the command set 2. |
| Switch on receiver 1 and switch off receiver 2 with the power switch. |
| Press and hold the button. |
| Enter "901" with the number buttons. |
| To adopt the code, press the button to switch receiver 1 to |
| standby and then switch off the device at the power switch. |
| Switch on receiver 2. |
| Press and hold the button. |
| Enter "902" with the number buttons. |
| To adopt the code, press the button to switch receiver 2 to |
| standby and then back into operation. Now switch on receiver 1 again. |
| Press and hold the button. |
| Enter "903" with the number buttons. |
| When carrying out the first two settings, the remote control must be |
| directed at the respective receiver (when switched on). |
| By pressing the button, you can now switch between the two |
| command sets A and B (toggle function) and alternately operate both |
| receivers. |
| Command set 1 is always active as the |
| If you are operating only one receiver and the active command set is |
| switched over by mistake so that this receiver can no longer be |
| operated, the remote control can be easily switched back to command |
| set 1. For this purpose, follow the procedure described above. |
10