Important note on setting up receiver on a UFO®micro system
When registering the receiver to a UFO®micro
-Connect the receiver to the TV set, but do not yet connect it to the ESU 32 antenna socket.
-Perform a UFO®micro reset on the receiver as described below.
1.Press the button to switch to the main menu.
2.Press the buttons to get to the installation menu and confirm your entry by pressing .
3.Press the buttons to get to the DiSEqC™ menu and confirm your entry by pressing .
4.Press the buttons to select the “UFO” option.
5.In the UFO menu press the buttons to select “UFO®micro”.
6.Press and change the selection to RESET with the buttons, then confirm your entry by pressing .
7.Press to exit the UFO menu (press to confirm the changes).
8.Press three times to get back to the starting point.
-Press the button to switch the receiver to standby mode.
-Now you can connect the receiver to the antenna socket.
-Press the button to switch the receiver on.
-The registration is then performed automatically – the screen briefly shows: “UFO® micro active”.
9