Kathrein UFS 702si, UFS 702sw manual Enter LO1 Enter LO2, Enter orbit position, Off

Satellites

Note:

2.Enter LO1

3.Enter LO2

At the factory LO1 and LO2 are preset to 9,750 MHz and 10,600 MHz.

If the LNB-LO frequencies differ from the factory presets, enter the relevant values here. Activate with  and use the number buttons -to enter the LO frequencies.

Press  to finish.

Please make sure that a digital-capable LNB is installed in your reception system.

4. Enter orbit position

The “Orbit position”, parameter, possible values 1-4, must be entered for control by DiSEqCTM.

DiSEqC™1.0	4 sat. positions 1-4
DiSEqC™1.1	16 x 4 sat. positions (uncommitted
	switches) 1-16/Off

As matrix operation switches are required to operate DiSEqCTM1.1, the cabling is highly complicated and should only be undertaken by an experienced installer!

Enable
{ON}	The selected satellite is enabled for your
	reception system.
{OFF}	The selected satellite is disabled.

5.Uncom.switch - Uncommitted switches in DiSEqC™- Mode

Uncommitted Switches (US) are used on special satellite reception systems to pre-select different groups.

In delivery status, the “Uncommitted switches” are deactivated = OFF.

39