Fujitsu MB2147-01 manual Settings for subclock selection, Fc Sel

										3.2 Clock Supply
			Table 3.2-1 Settings for main clock selection
				Main clock source			FC SEL setting
							1		2
			Clock area				OFF		OFF
			User system				ON		ON
Table 3.2-2	Settings for subclock selection
	Subclock					FC SEL
						setting
									SUB XTAL setting
Availability	Source(*1)	Pin corresponding to				3	4
		the evaluation MCU(*2)
Available	Clock area	PGA			X1A: Pin No. 267	OFF	OFF	X1A:B connected to X1A:C		X0A:B connected to X0A:C
		299			X0A: Pin No. 217			(a) in Figure 3.2-3		(a) in Figure 3.2-3
					X1A: Pin No. 217	OFF	OFF	X1A:B connected to X0A:B		X1A:C connected to X0A:C
					X0A: Pin No. 267			(b) in Figure 3.2-3		(b) in Figure 3.2-3
		PGA			X1A: Pin No. 51	OFF	OFF	X1A:B connected to X1A:C		X0A:B connected to X0A:C
		256			X0A: Pin No. 176			(a) in Figure 3.2-3		(a) in Figure 3.2-3
					X1A: Pin No. 176	OFF	OFF	X1A:B connected to X0A:B		X1A:C connected to X0A:C
					X0A: Pin No. 51			(b) in Figure 3.2-3		(b) in Figure 3.2-3
Not				-		ON	ON	X1A:A connected to X1A:B		X0A:A connected to X0A:B
available								(c) in Figure 3.2-3		(c) in Figure 3.2-3

*1: Clock oscillation with a crystal unit mounted in the user system is not supported.

*2: In the table, PGA299 and PGA256 indicate different adapter boards, which are: PGA299: Adapter board for the PGA-299P

PGA256: Adapter board for the PGA-256P

The correspondence between subclock signals (X0A and X1A) and pin numbers on the evaluation MCU depends on the evaluation MCU used. Check the correspondence before making settings.

For more information on the correspondence between subclock signals and pin numbers on the evaluation MCU, contact the Fujitsu Sales Dept. or Support Dept.

Note:

To supply the main clock signal from the user system, add an oscillation circuit to the user system and have the main clock supplied via a CMOS buffer.

37