Chief Manufacturing 8805-000009 manual Wiring the RC-10

Instruction Manual Plasma Display Electric Pop-Up Lift

		Extends unit to preset travel limit.		If using Latching Switch, be sure to
11
	EXTEND	Customer within a preset maximum		disengage Switch prior to initiating any
		range may adjust travel limits.		other function.
			Momentary or Latching contact to
		Retracts unit to preset travel limit.	Ground terminals 3, 10, 13, or 20.
				If using Latching Switch, be sure to
12	RETRACT	Travel limits may be adjusted by
				disengage Switch prior to initiating any
		customer within a preset maximum		other function.
		range.
13	GROUND	Ground
14	EXTEND	Immediately reverses direction of		Chief Mfg. offers the SS-10 Pressure
		travel when triggered while unit is		Sensitive Safety Strip to provide this
	ERROR
		extending.	Momentary contact to Ground	function.
				Please specify how many inches required
			terminals 3, 10, 13, or 20.
		Immediately reverses direction of		spanning entire pinch zone.
15	RETRACT			The SS-10 must be ordered with the ST-1
		travel when triggered while unit is
	ERROR			Terminals.
		retracting.
16	EXTEND
	LIMIT
	RELAY
		Closes set of internal dry contacts		RATED FOR 1 AMP @ 24 VOLTS
	EXTEND	when unit reaches full extension.
17	LIMIT
	RELAY
	COMMON
18	RETRACT
	LIMIT
	RELAY
		Closes set of internal dry contacts		RATED FOR 1 AMP @ 24 VOLTS
	RETRACT	when unit reaches full retraction.
19	LIMIT
	RELAY
	COMMON
20	GROUND	Ground

WIRING THE RC-10

Connect white lead to terminal 1, red lead to terminal 2, and black lead to terminal 5.

Place jumper wire from terminal 2 to terminal 6

WIRING A MOMENTARY PUSH BUTTON

Connect terminals 3 & 6 with Jumper Wire. Connect Momentary Switch to terminal 4. Connect other line of Momentary Switch to terminal 5.

21