Instruction Manual | Plasma Display Electric |
PREPARE THE FURNITURE/CABINET AND INSTALL THE LIFT
Because of the wide variety of possible mounting situations, Chief Manufacturing can only provide general guidelines for lift installation. Study the following information carefully, and adapt it as necessary to fit your specific installation.
WARNING: Be especially aware of the weight of the unit, and the potential for personal injury or of damage to the unit if it is not adequately mounted. The lift (without a projector) weighs approximately 150 lbs (68 kg).
The “General Guidelines” below and the information on the following pages cover the most common mounting situa- tions:
General Guidelines
•Compare the inside dimensions of the furniture/cabinet in which the lift will be installed with the dimensional requirements of your display and any additional space required for your application. Allow for movement of the lift and the display.
Prepare the Furniture/Cabinet
WARNNG: Be aware during the instal- lation that this is a motorized device, and there are pinch points for people and for electrical wiring. Keep hands and electrical wiring away from inter- nal components of the mechanism
1.Determine size and weight of display to be lifted. See
“Weight, Size, and Vertical Travel” on page 3 for weight limitations.
2.Determine vertical travel height required for presentation viewing. See Table 1 for height limitations.
Furniture Opening Finish Piece Options
Because of the wide variety of possible mounting sit- uations, Chief Manufacturing can only provide gen- eral guidelines for finish options. Study the following information carefully, and adapt it as necessary to fit your specific installation.
NOTE: Always leave access to the lift for maintenance pur- poses.
Extended Position Finish Piece Option
A finish piece, covering the opening when the unit is in the fully extended position, may be installed for estetic purposes. Using the material cut slight smaller than the opening size, install the finish piece as fol- lows:
1.Measure the width of the finish piece.
2.Measure the distance between the verticle extrusion arms and subtract a nominal amount for clearance.
CAUTION: Failure to allow clearance for the finish piece to retract to the fully lowered position may result in damage to the fin- ish piece, damage to the lift, and damage to the plasma.
6