Chief Manufacturing 8805-000009 manual Retracted Position Finish Piece Option

Instruction Manual Plasma Display Electric Pop-Up Lift

3.Make sure the finish piece measured in step 1 is smaller than the clearance distance measured in step 2 and note any cord management access holes that may be necessary.

4.Measure the thickness of the finish piece, add this thickness to the length of the five capscrews used to secure the plasma mounting assembly when a backing is not used, and obtain the five longer 3/8-16 capscrews for assembly with backing.

5.Place the finish piece on the shelf, making sure it is correctly positioned to allow clearance when lowered, and transfer the pattern of the five access holes onto the finish piece.

6.Drill five through holes, with clearance for 3/8” bolts, in the finish piece and any cord management holes that may be nec- essary.

7.Place the finish piece on the shelf.

8.Place the plasma mounting assembly on top of the finish piece (see Figure 5).

9.Using a 5/16” Allen wrench inserted through the five access holes on the bottom of the shelf (see Figure 6), install five longer 3/8-16 cap screws.

10.With the aid of another person, lift the display up to the mount, aligning the PSB mounting buttons on the display with the teardrop slots on the mount, set the plasma into place and adjust mounting assembly to ensure proper clearance is achieved.

11.Measure and record clearance dimensions and, with the aid of another person, remove plasma.

WARNNG: Be aware during the installa- tion that this is a motorized device, and there are pinch points for people and for electrical wiring. Keep hands and electri- cal wiring away from internal components of the mechanism

12.Carefully, without plasma mounted on lift, operate lift to ensure finish piece has sufficient clearance during full travel.

Retracted Position Finish Piece Option

A finish piece, covering the opening when the unit is retracted, may be installed for estetic purposes. Install the finish piece as follows:

1.Complete the instructions in “Extended Position Finish Piece Option” on page 6.

2.Cut two side pieces, matching the width of the extended posi- tion finish piece, to a length slightly longer than the distance the plasma will travel (this will be trimmed later).

3.Cut a top piece, matching the dimensions of your extended position finish piece (see Figure 7).

Plasma Mounting
Assembly	Shelf

Figure 5. Plasma Mounting Assembly

Access Holes

Figure 6. Access Holes

7