Chief Manufacturing 8805-000009 manual Retracted Position Finish Piece Furniture

Page 9

Instruction Manual

Plasma Display Electric Pop-Up Lift

4.With the extended position finish piece and the plasma- mounted, lower the unit to its fully retracted position.

5.Place the side pieces in position (do not attach).

6.Place the top piece in position (do not attach).

7.Measure the distance from the top surface of the top piece to the top surface of your furniture and cut this dimension from each side piece (see Figure 8).

8.Remove and assemble finish pieces (bottom, sides and top), making sure your finished box is square.

CAUTION: A backing is recommended for support. Frame move- ment could result in damage to the frame, damage to the lift, and damage to the plasma.

CAUTION: Check plasma ventilation requirements. Provide ven- tillation for your application.

9.Measure box, construct a backing for lateral support, and install backing.

WARNNG: Be aware during the installation that this is a motorized device, and there are pinch points for people and for electrical wiring. Keep hands and electrical wiring away from internal components of the mechanism

CAUTION: Failure to allow clearance for the finish pieces to retract to the fully lowered position may result in damage to the finish pieces, damage to the lift, and damage to the plasma.

10. Carefully, without plasma mounted on lift, operate lift to ensure the finish pieces have sufficient clearance during full travel

and that top finish piece is flush with the furniture top when fully retracted.

Retracted Position

Backing

Finish Piece

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Side Pieces

Plasma

Extendeded Position

Finish Piece

Figure 7. Retracted Position Finish Piece

Finish Piece

Furniture

Figure 8. Side Piece Dimensions

8

Image 9
Contents Before YOU Begin Plasma Display Electric Pop-Up Lift PULWEIGHT, SIZE, and Vertical Travel Specifications Tools Required for InstallationContents Weight, Size, and Vertical Travel Model Front View Dimensional DrawingInspect and Test the Unit Before Installing Inspect The UnitTest The Unit General Guidelines Prepare the FURNITURE/CABINET and Install the LiftPrepare the Furniture/Cabinet Furniture Opening Finish Piece OptionsRetracted Position Finish Piece Option Retracted Position Finish Piece Furniture Secure Lift Install the PUL into the CabinetInstall the Display on the Lift Attach Brackets to the DisplayMount the Display Adjustments Width AdjustmentAdjust Vertical Travel This page Intentionally Blank Pushbutton Wiring ExamplesThis page Intentionally Blank Red lead Black lead Remote RC-10This page Intentionally Blank Volt Out Supply Two Dry Contact ClosuresLow Voltage Sensing This page Intentionally Blank Possible Symptoms Causes Suggested Action TroubleshootingDescription Wiring Options Wiring the RC-10