Chief Manufacturing 8805-000009 manual Contents

Page 3

Instruction Manual	Plasma Display Electric Pop-Up Lift
CONTENTS
WEIGHT, SIZE, AND VERTICAL
TRAVEL SPECIFICATIONS	3
DIMENSIONAL DRAWING	4
INSPECT AND TEST THE UNIT
BEFORE INSTALLING	5
Inspect The Unit	5
Test The Unit	5
PREPARE THE FURNITURE/CABINET
AND INSTALL THE LIFT	6
General Guidelines	6
Prepare the Furniture/Cabinet	6
Furniture Opening Finish Piece Options	6
Extended Position Finish Piece Option	6
Retracted Position Finish Piece Option	7
Install the PUL into the Cabinet	9
INSTALL THE DISPLAY ON THE LIFT	10
Attach Brackets to the Display	10
Mount the Display	10
ADJUSTMENTS	11
Width Adjustment	11
Adjust Vertical Travel	11
WIRING	13
Pushbutton	13
Extend and Retract Terminals to beTriggered by
Separate Dry Contacts	13
Remote (RC-10)	15
12 Volt Out Supply	17
24 Volt Out Supply	17
Two Dry Contact Closures	17
Low Voltage Sensing	17
TROUBLESHOOTING	19

2

Image 3

Contents Before YOU Begin Plasma Display Electric Pop-Up Lift PULWEIGHT, SIZE, and Vertical Travel Specifications Tools Required for InstallationContents Weight, Size, and Vertical Travel Model Front View Dimensional DrawingInspect and Test the Unit Before Installing Inspect The UnitTest The Unit Furniture Opening Finish Piece Options Prepare the FURNITURE/CABINET and Install the LiftGeneral Guidelines Prepare the Furniture/CabinetRetracted Position Finish Piece Option Retracted Position Finish Piece Furniture Secure Lift Install the PUL into the CabinetInstall the Display on the Lift Attach Brackets to the DisplayMount the Display Adjustments Width AdjustmentAdjust Vertical Travel This page Intentionally Blank Pushbutton Wiring ExamplesThis page Intentionally Blank Red lead Black lead Remote RC-10This page Intentionally Blank Volt Out Supply Two Dry Contact ClosuresLow Voltage Sensing This page Intentionally Blank Possible Symptoms Causes Suggested Action TroubleshootingDescription Wiring Options Wiring the RC-10