Chief Manufacturing 8805-000009 manual Wiring Examples, Pushbutton

Page 14

Instruction Manual

Plasma Display Electric Pop-Up Lift

 

 

WIRING EXAMPLES

The information on the following pages cover the most common wiring options:

Pushbutton

Extend and Retract Terminals to be Triggered By Separate Dry Contacts

Remote (RC-10)

12 Volt out supply

24 Volt out supply

Two dry contact closures

Figure 16. 12 Volt Supply Jumper

 

Voltage Sensing

 

Pushbutton

Wire for pushbutton operation as follows:

1.Install a wire between terminal 5 (extend/retract common) and ground terminal 3 (see Figure 16).

2.Connect one wire from pushbutton to terminal #4

(12 VDC power supply) and the other wire from the pushbut-

Figure 17. Pushbutton Wires

ton to terminal #6 (extend/retract) (see Figure 17).

 

With the unit plugged in, push the button once and the unit should

 

extend. Push the button during travel and the unit will stop at that

 

location. Push the button after the unit is extended or stopped in

 

mid-travel and the unit will retract.

 

Extend and Retract Terminals to be Triggered By

Common

Separate Dry Contacts

 

These terminals can be used with a wall switch or a separate set of

dry contacts for dedicated extend and dedicated retract. Momentary Figure 18. Common for Extend and Retract Contacts contacts are preferable.

NOTE: The connection between the ground (#13) and any other

Service Extend

 

terminal connection must be broken (open) before completing the

 

next circuit.

Extend

1. Connect the common to terminal #13 (see Figure 18).

 

2. Connect the extend to terminal #11 (see Figure 19).

 

3. Connect the retract to terminal #12 (see Figure 20).

Figure 19. Extend Contact Wiring

Completing the circuit between terminal #13 and terminal #11 will

 

cause the unit to extend to the show position (see “Adjust Vertical

 

Travel” on page 11 to change height setting). Completing the cir-

 

cuit between terminal #13 and terminal #12 will cause the unit to

 

retract to the closed position.

 

 

Retract

 

Figure 20. Retract Contact Wiring

13

Image 14
Contents Plasma Display Electric Pop-Up Lift PUL Before YOU BeginTools Required for Installation WEIGHT, SIZE, and Vertical Travel SpecificationsContents Weight, Size, and Vertical Travel Model Dimensional Drawing Front ViewTest The Unit Inspect and Test the Unit Before InstallingInspect The Unit Prepare the Furniture/Cabinet Prepare the FURNITURE/CABINET and Install the LiftGeneral Guidelines Furniture Opening Finish Piece OptionsRetracted Position Finish Piece Option Retracted Position Finish Piece Furniture Install the PUL into the Cabinet Secure LiftMount the Display Install the Display on the LiftAttach Brackets to the Display Adjust Vertical Travel AdjustmentsWidth Adjustment This page Intentionally Blank Wiring Examples PushbuttonThis page Intentionally Blank Remote RC-10 Red lead Black leadThis page Intentionally Blank Low Voltage Sensing Volt Out SupplyTwo Dry Contact Closures This page Intentionally Blank Troubleshooting Possible Symptoms Causes Suggested ActionDescription Wiring Options Wiring the RC-10