Operating Instruction Book
| HD (YPbPr) | HD (RGB) |
| SD (CVBS) | |||
| LCD/Plasma | CRT | LCD/Plasma | CRT | LCD/Plasma | CRT | |
576i | X | X |
|
|
| X | X |
576p | X | X | X |
| X |
|
|
1080i | X | X | X |
| X |
|
|
1152i |
| X |
|
| X |
|
|
720p | X |
| X |
|
|
|
|
Table 1: Output format table
When all formats have been tested, a list of all accepted video formats will be displayed. You will have the option to accept this list or to start the procedure again.
The accepted display formats are then displayed and you are requested to select your preferred display format, or to select Dynamic Format Selection. When Dynamic Format Selection is selected, the digital receiver will choose the best format for the received digital program. The selected output format can be changed at any stage in the Preferences menu (section 6.3).
Anytime you change the rear panel switch or change display device, you will have to restart the procedure again.
4.3Audio Display setting
During the format set up, if you select Plasma / LCD as the display type, your digital receiver will ask you to set up Lip Sync Compensation. Generally speaking, Plasma Display Panels introduce a slight time delay in the picture, which may cause a problem with lip sync. Use S/T on the remote control to select the delay and confirm by pressing OK. Typically this delay is in the order of 20 – 40 ms. You can adjust the delay later in the Preferences menu (section 6.3).
4.4Select Region
The first time the digital receiver is installed, or after Shipping Condition is restored (section 6.4), you will be asked to select relevant region in order that the digital receiver may display the correct local time.
11