Technicolor - Thomson TU-HDT104A manual Output Mode Selection, Installation Format Selection

Page 9

Operating Instruction Book

TU-HDT104A

4.2Output Mode Selection

After you have connected the AV cables for video and audio between your digital receiver and the display device, check that the position of the output selection switch is correct for your chosen connection method as in the table below.

Switch Position

Video Output Format

Receiver Mode

A

YPbPr (Component Video)

SD / HD

B

RGB

HD

C

CVBS / S-Video

SD

Switch on the digital receiver and the display device, and select the correct AV input on the display device. The digital receiver will take about 10 seconds to switch on. You may now start the installation procedure.

The installation procedure is used to set up the video formats that may be output from the digital receiver to the display device. During this procedure the digital receiver may test if the display device is capable of correctly displaying 576i, 576p, 1152i, 1080i and 720p video formats. You will be asked to test these video formats on the display device and confirm if the picture is displayed correctly. If the display device is not capable of displaying a particular video format, the digital receiver will return to the last correctly displayed format after about 8 seconds.

Note: In some cases, a display device will fail to return to a previously tested mode after failing to display the next mode (i.e. the display does not support this format). If you experience this, turn the display device off, wait 10 seconds and then turn the display device on.

Installation Format Selection

Use the Remote Control keypad to perform the digital receiver format testing and installation. Follow the digital receiver’s on-screen instructions to do the installation.

Mode A (SD/HD, YPbPr)

The switch on the rear of the digital receiver must be in position A, and the AV connections must be taken from the YPbPr RCA sockets. The digital receiver display will show “HdcI”. Press OK to confirm the selection, or switch to another mode. Proceed to

INSTALLATION.

Note: If the display device is not capable of displaying 576i, you can press the Mosaic button to change to 576p.

9

Image 9
Contents Trademark Acknowledgment and license notice TU-HDT104AWelcome Contents Important First time Installers Digital ReceiverFront Panel Box Contents Remote ControllerPreparing the Remote Controller Rear PanelControl Panel Installing Your Digital Receiver Audio Connections Mode C SD, TV/CVBSInstallation Format Selection Output Mode SelectionInstallation Mode C SD, CvbsSelect Region Audio Display settingOperating Instructions Knowing your basic controls Switching On Your Digital ReceiverSelect Aspect Ratio AutotuneChanging or Selecting Channels Information PlateAudio Selection Using the Main Menu Coloured Hot Keys Program Guide Programs ScheduleBooked Programs Category SelectionPreferences TV/Radio ChannelsAudio delay time VCR outMpeg Audio Level Audio Preference Audio Language PriorityDownmix-Surround Digital AudioAudio Balance Select Output FormatAdvanced Settings Change passwordParental Guidance Restore shipping condition InstallAuto Scan channels Manual Channel SearchSoftware download Box InformationGlossary What to do if you can’t solve the problem TroubleshootingSD/HD Technical SpecificationsTU-HDT104A Warranty