Technicolor - Thomson TU-HDT104A manual Installing Your Digital Receiver

Operating Instruction Book

TU-HDT104A

4 Installing Your Digital Receiver

4.1Connecting Your Digital Receiver

The following illustrations show some examples for connecting this HD Digital Receiver. Select the connection that is best suited for your needs. Many other connections may be possible when optional devices such as RF cable splitters are included in your system. These devices may cause signal degradation and, if too many are used, poor quality picture and sound may result.

Terrestrial antenna/cable connection

Connect the TV antenna cable to the HD Digital Receiver RF IN connector. Also connect the cable between your TV Antenna IN and RF Out connector on the rear of the Digital Receiver. This connection allows your TV set to receive normal analogue programs. (Refer to A)

Video Connections (A) Aerial Connection

Adjust switch on the rear panel according to the format supported by your display device, and it contains three modes: A, B and C

Mode A (SD/HD, YPbPr)

Connect the YPbPr component video output socket on your digital receiver to your display device’s YPbPr component video input. Be sure to match the colours on the RCA sockets with the coloured plugs. (Refer to B)

Note: When unit is in Mode A, there is no video output from the CVBS TV socket.

Mode B (HD, RGB)

Connect the D-sub socket to your display device. (Refer to C)

Note: Cable is not supplied.

(B) YPbPr Connection

(C) RGB Connection

7