Yamaha DVD-S795 manual Safety information, Risk of Electric Shock Do not Open

Page 2

Safety information

Note:

This player can be used only where the power supply is AC 120 V, 60 Hz. It cannot be used elsewhere.

CAUTION:

DVD/VIDEO CD/CD PLAYER IS A CLASS I LASER

PRODUCT. HOWEVER THIS DVD/VIDEO CD/CD PLAYER USES A VISIBLE LASER BEAM WHICH COULD CAUSE HAZARDOUS RADIATION EXPO- SURE IF DIRECTED. BE SURE TO OPERATE THE DVD/VIDEO CD/CD PLAYER CORRECTLY AS IN- STRUCTED.

WHEN THIS DVD/VIDEO CD/CD PLAYER IS PLUGGED TO THE WALL OUTLET, DO NOT PLACE YOUR EYES CLOSE TO THE OPENING OF THE DISC TRAY AND OTHER OPENINGS TO LOOK INTO THE INSIDE OF THIS PLAYER.

USE OF CONTROLS OR ADJUSTMENTS OR PER- FORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PLAYER TO RAIN OR MOISTURE.

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, AND ANNOYING INTERFERENCE, USE THE SUPPLIED ACCESSORIES ONLY.

This player is not disconnected from the AC power source as long as it is connected to the wall outlet, even if this player itself is turned off. This state is called the standby mode.

In this state, this player is designed to consume a very small quantity of power.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PER- SONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous volt- age” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral trian- gle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the ap- pliance.

CAUTION -LASER RADIATION WHEN OPEN.

DO NOT STARE INTO BEAM.

ATTENTION-RAYONNEMENT LASER EN CAS D'OUVERTURE.

NE PAS REGARDER DANS LE FAISCEAU.

VORSICHT -LASERSTRAHLUNG, WENN ABDECKUNG GEÖFFNET.

NICHT IN DEN STRAHL BLICKEN.

ADVARSEL -LASERSTRÅLING VED ÅBNING.

SE IKKE IND I STRÅLEN.

ADVARSEL -LASERSTRÅLING NÅR DEKSEL ÅPNES.

STIRR IKKE INN I STRÅLEN.

VARNING

-LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD.

 

STIRRA EJ IN I STRÅLEN.

VARO!

-AVATTAESSA OLET ALTTIINA LASERSÄTEILYLLE.

 

ÄLÄ TUIJOTA SÄTEESEEN.

注意�- ここを開くとレーザー光が出ます。

レーザー光をのぞき込まないでください。

(Inside of player)

FOR CANADIAN CUSTOMERS

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT AND FULLY INSERT.

THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.

2

Image 2
Contents DVD-S795 Safety information Risk of Electric Shock Do not OpenPrecautions FCC Information for U.S.AAccessories Table of contents Features Definition of terms Main unit Remote control unitControl reference guide STANDBY/ON buttonFront panel FL display Connection For your reference Component video output connectors Y, CB, CRVideo output connector Connection Battery installation a Remote control unit preparationConnecting headphones C Remote control operation range BBasic play Basic playStopping play Press Skip H, I during play Skipping ahead or backStill picture Pause Press STILL/PAUSE during playFrame advance Frame reverse Rapid advance Rapid reverseSlow-motion play DVD/Video CD General information about On- Screen Menu Icons Common proceduresPress on Screen during play or in the stop mode Press the cursor buttons C, D to select the preferred itemDetailed descriptions of each On-Screen Menu Icon Screen for disc information For DVDTrack No Audio modeScreen for disc information For Video CD/CD Playback controlScreen for player information Shuttle screen Press Repeat during play Repeat playRepeat viewing listening To return to normal playTo return to program play Repeating sections between two Specific points A-B repeatRepeat play To enjoy program repeat play Repeat of programmed trackClearing the program To return to normal play Press Play Mode in the stop modeProgram play Video CD/CD Press SelectStoring a marker in the memory Press Play Mode twice in the stop modeStoring markers in memory to be viewed listened to again Random play Video CD/CDStoring markers in memory to be viewed listened to again Changing audio soundtrack language DVDRecalling/clearing a marker Press Audio during playJe t’aime Changing subtitle language DVDLove you Viewing from another angle DVD Using a title menu DVDUsing a DVD menu DVD Press SET UP in the stop mode Initial settingsCommon procedures of initial settings To cancel during setup operationSelecting disc languages DVD When level 7 or lower is selected Selecting rating level DVDWhen the player is locked Selecting language of On-Screen Display menuSelecting the display format On-Screen Display When 1 On-Screen Messages is selectedWhen 2 Color and Position is selected On-Screen MessagesDim Selecting the FL display brightnessBright Dim During DVD/VCD Play AutoSelecting TV screen type Formatted Pan & ScanStyle Pan & Scan style SoftwareDolby Digital Selecting digital outputLpcm 96k48k DtsRecommended setting of Digital Audio Out- put Speaker settings To adjust the channel balance using the test signal Delay timeSpeaker Delay time Difference between D1 D2/D3 Other settings When 4 D. Dynamic Range Compression is selected When 2 Audio during Search is selectedWhen 3 TV Mode 43 is selected When 5 Still Picture Display is selectedLanguage code list Disc handling and maintenance MaintenanceTroubleshooting Symptom Common RemedySelf-diagnosis display function Specifications