Yamaha DVD-S795 manual Troubleshooting, Symptom Common Remedy

Page 46

Troubleshooting

If the player fails to operate normally, check the following points to determine whether the fault can be corrected by the simple mea- sures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the AC cord and contact your authorized YAMAHA dealer or service center for help.

Symptom (Common)

Remedy

No power.

Insert the AC plug securely into the AC cord.

 

 

The player is automatically set to the

To conserve power, the player is automatically set to the standby mode after

standby mode.

approx. 30 minutes have elapsed in the stop mode (Auto power-off function). Turn

 

the power back to ON.

 

 

ÁPlay fails to start even when PLAY is

ÁCondensation has formed: wait about 1 to 2 hours to allow the player to dry out.

pressed.

ÁThis player cannot play a disc other than DVD, Video CD and CD.

ÁPlay starts but then stops immediately.

ÁThe disc may be dirty and may require cleaning.

 

ÁEnsure that the disc is installed with the label side up to be played facing upwards.

 

 

No picture.

ÁEnsure that the equipment is connected properly.

 

ÁEnsure that the input setting for the TV is “Video”.

 

 

ÁNo sound.

ÁEnsure that the equipment is connected properly.

ÁDistorted sound.

ÁEnsure that the input settings for the TV and stereo system are correct.

 

ÁAdjust the master volume using the On-Screen Menu Icon for player information.

 

 

Picture is distorted during rapid advance

The picture will be somewhat distorted at times: this is normal.

or rapid reverse.

 

 

 

No key operation (by the main unit and/or

ÁSome operations may be prohibited by the disc.

the remote control unit) is effective.

ÁPress POWER to set the player to the standby mode and then back to ON.

 

Alternatively, press POWER to set the player to the standby mode, disconnect the

 

AC plug and then re-connect it. (The player may not be operating properly due to

 

lightning, static electricity or some other external factor.)

 

 

No 4:3 (16:9) picture.

Choose the correct setup “6 TV Aspect” item which matches the TV set used.

 

 

No on-screen display.

The “Off” setting is selected for “1 On-Screen Messages” in “4 On-Screen

 

Messages”: select “On”.

 

 

No operations can be performed with the

ÁTo conserve power, the player is automatically set to the standby mode after

remote control unit.

approx. 30 minutes have elapsed in the stop mode (Auto power-off function).

 

Turn the power back to ON.

 

ÁCheck the batteries are installed with the correct polarities (o and p).

 

ÁThe batteries are depleted: replace them with new ones.

 

ÁPoint the remote control unit at the remote control sensor and operate.

 

ÁOperate the remote control unit at a distance of not more than 23 feet (7 m) from

 

the remote control sensor.

 

ÁRemove the obstacles between the remote control unit and remote control sensor.

 

 

On-Screen Menu Icons not displayed or

Change the position of the On-Screen Menu Icon using “2 Color and Position” in

only partially displayed on the TV screen.

“4 On-Screen Messages” of the initial settings.

 

 

46

Image 46
Contents DVD-S795 Safety information Risk of Electric Shock Do not OpenPrecautions FCC Information for U.S.AAccessories Table of contents Features Definition of terms Main unit Remote control unitControl reference guide STANDBY/ON buttonFront panel FL display Connection Video output connector Component video output connectors Y, CB, CRFor your reference Connection Battery installation a Remote control unit preparationConnecting headphones C Remote control operation range BBasic play Basic playStopping play Press Skip H, I during play Skipping ahead or backStill picture Pause Press STILL/PAUSE during playSlow-motion play DVD/Video CD Rapid advance Rapid reverseFrame advance Frame reverse General information about On- Screen Menu Icons Common proceduresPress on Screen during play or in the stop mode Press the cursor buttons C, D to select the preferred itemDetailed descriptions of each On-Screen Menu Icon Screen for disc information For DVDTrack No Audio modeScreen for disc information For Video CD/CD Playback controlScreen for player information Shuttle screen Press Repeat during play Repeat playRepeat viewing listening To return to normal playTo return to program play Repeating sections between two Specific points A-B repeatRepeat play To enjoy program repeat play Repeat of programmed trackClearing the program To return to normal play Press Play Mode in the stop modeProgram play Video CD/CD Press SelectStoring a marker in the memory Press Play Mode twice in the stop modeStoring markers in memory to be viewed listened to again Random play Video CD/CDStoring markers in memory to be viewed listened to again Changing audio soundtrack language DVDRecalling/clearing a marker Press Audio during playLove you Changing subtitle language DVDJe t’aime Using a DVD menu DVD Using a title menu DVDViewing from another angle DVD Press SET UP in the stop mode Initial settingsCommon procedures of initial settings To cancel during setup operationSelecting disc languages DVD When level 7 or lower is selected Selecting rating level DVDWhen the player is locked Selecting language of On-Screen Display menuSelecting the display format On-Screen Display When 1 On-Screen Messages is selectedWhen 2 Color and Position is selected On-Screen MessagesDim Selecting the FL display brightnessBright Dim During DVD/VCD Play AutoSelecting TV screen type Formatted Pan & ScanStyle Pan & Scan style SoftwareDolby Digital Selecting digital outputLpcm 96k48k DtsRecommended setting of Digital Audio Out- put Speaker settings Speaker Delay time Difference between D1 D2/D3 Delay timeTo adjust the channel balance using the test signal Other settings When 4 D. Dynamic Range Compression is selected When 2 Audio during Search is selectedWhen 3 TV Mode 43 is selected When 5 Still Picture Display is selectedLanguage code list Disc handling and maintenance MaintenanceTroubleshooting Symptom Common RemedySelf-diagnosis display function Specifications