Yamaha DVD-S795 manual Disc handling and maintenance, Maintenance

Page 45

 

 

Disc handling and maintenance

A

 

 

Handling precautions

 

 

 

ÁHold the disc by the edges so the surface will not be soiled

 

 

with fingerprints. (A)

 

 

 

Fingerprints, dirt and scratches can cause skipping and dis-

 

 

tortion.

 

 

 

ÁDo not write on the label side with a ball-point pen or other

 

 

writing utensils.

 

 

 

ÁDo not use record cleaning sprays, benzine, thinner, static

 

 

electricity prevention liquids or any other solvent.

 

 

ÁBe careful not to drop or bend the disc.

 

 

ÁDo not install more than 1 disc on the disc tray.

 

 

ÁDo not try to close the disc tray when the disc is not installed

 

 

properly. (B)

 

 

 

ÁBe sure to store the disc in its exclusive case when not in

 

 

use.

 

 

 

If the surface is soiled C

 

 

 

Wipe gently with a soft, damp (water only) cloth.

 

 

When wiping discs, always move the cloth from the center hole

 

 

toward the outer edge.

 

 

 

(If you wipe the discs using a circular motion, circular scratch-

B

 

 

es are likely to occur, which will cause noise.)

 

 

 

If the disc is brought from a cold to a warm en-

 

 

vironment, moisture may form on the disc

 

 

Wipe this moisture off with a soft, dry, lint-free cloth before us-

 

 

ing the disc.

 

 

 

Improper disc storage

 

 

 

You can damage discs if you store them in the following

 

 

places:

 

 

 

ÁAreas exposed to direct sunlight

 

 

ÁHumid or dusty areas

 

 

 

ÁAreas directly exposed to a heat outlet or heating appliance

 

 

Discs which cannot be played with this player

 

 

ÁDVD with Region No. other than “1” or “ALL”

 

 

ÁDisc of PAL system

ÁCD-G

 

 

ÁDVD-ROM

ÁCD-RW

 

 

ÁDVD-R/DVD-RAM

ÁDVDGRW

 

 

ÁCD-ROM

ÁCVD

 

 

ÁVSD

ÁSVCD

C

 

ÁCDV

ÁDivx Video Disc

 

etc.

 

 

 

 

ÁDo not try to play Photo CD or CD-R. (Otherwise, data on the disc may be damaged.)

To prevent a malfunction of this player

ÁDo not use any non standard shaped CD (heart etc.) avail- able on the market, because it may damage the player.

ÁDo not use a CD with tape, seals, or paste on it, because damage to the player may result.

Maintenance

ÁBe sure to press POWER to set the player to the standby mode and disconnect the AC cord before maintaining the player.

ÁWipe this player with a dry, soft cloth.

If the surfaces are extremely dirty, wipe clean with a cloth which has been dipped in a weak soap-and-water solution and wrung out thoroughly, and then wipe again with a dry cloth.

ÁNever use alcohol, benzine, thinner, cleaning fluid or other chemicals. And do not use compressed air to remove dust.

Initial Settings

For Your Reference

45

Image 45
Contents DVD-S795 Risk of Electric Shock Do not Open Safety informationFCC Information for U.S.A PrecautionsAccessories Table of contents Features Definition of terms Control reference guide Remote control unitMain unit STANDBY/ON buttonFront panel FL display Connection Component video output connectors Y, CB, CR Video output connectorFor your reference Connection Connecting headphones C Remote control unit preparationBattery installation a Remote control operation range BBasic play Basic playStopping play Still picture Pause Skipping ahead or backPress Skip H, I during play Press STILL/PAUSE during playRapid advance Rapid reverse Slow-motion play DVD/Video CDFrame advance Frame reverse Press on Screen during play or in the stop mode Common proceduresGeneral information about On- Screen Menu Icons Press the cursor buttons C, D to select the preferred itemScreen for disc information For DVD Detailed descriptions of each On-Screen Menu IconScreen for disc information For Video CD/CD Audio modeTrack No Playback controlScreen for player information Shuttle screen Repeat viewing listening Repeat playPress Repeat during play To return to normal playRepeat play To enjoy program repeat play Repeating sections between two Specific points A-B repeatTo return to program play Repeat of programmed trackProgram play Video CD/CD To return to normal play Press Play Mode in the stop modeClearing the program Press SelectStoring markers in memory to be viewed listened to again Press Play Mode twice in the stop modeStoring a marker in the memory Random play Video CD/CDRecalling/clearing a marker Changing audio soundtrack language DVDStoring markers in memory to be viewed listened to again Press Audio during playChanging subtitle language DVD Love youJe t’aime Using a title menu DVD Using a DVD menu DVDViewing from another angle DVD Common procedures of initial settings Initial settingsPress SET UP in the stop mode To cancel during setup operationSelecting disc languages DVD Selecting rating level DVD When level 7 or lower is selectedSelecting language of On-Screen Display menu When the player is lockedWhen 2 Color and Position is selected When 1 On-Screen Messages is selectedSelecting the display format On-Screen Display On-Screen MessagesBright Selecting the FL display brightnessDim Dim During DVD/VCD Play AutoSelecting TV screen type Style Pan & ScanFormatted Pan & Scan style SoftwareLpcm 96k48k Selecting digital outputDolby Digital DtsRecommended setting of Digital Audio Out- put Speaker settings Delay time Speaker Delay time Difference between D1 D2/D3To adjust the channel balance using the test signal Other settings When 3 TV Mode 43 is selected When 2 Audio during Search is selectedWhen 4 D. Dynamic Range Compression is selected When 5 Still Picture Display is selectedLanguage code list Maintenance Disc handling and maintenanceSymptom Common Remedy TroubleshootingSelf-diagnosis display function Specifications