Furuno GP-1650DF, GP-1650F manual General, GPS Receiver, Display Section, Plotter

Page 104

SPECIFICATIONS OF

COLOR GPS/ PLOTTER/ SOUNDER: GP-1650F

COLOR DGPS/ PLOTTER/ SOUNDER: GP-1650DF

1. GENERAL

 

(1)

Display

5.6 inch high resolution color LCD

(2)

Projection

Mercator

(3)

Usable Area

85° latitude or below

(4)

Display Mode

Plotter, Plotter/Sounder, Sounder, Highway display,

 

 

Waypoint display, XTE(Cross Track Error) display

(5)

Alarms

Arrival and Anchor watch, Cross track error and border alarms,

 

 

Ships speed in and out alarms, Water temperature, Fish school

2. GPS RECEIVER

 

(1)

Receiving Channels

12 channels parallel, 12 satellite tracking

(2)

Rx Frequency

1575.42 MHz

(3)

Rx Code

C/A code

(4)

Position Fixing System

All in view, 8-state Kalman filter

(5)

Position Accuracy

Approx. 10 m, 95% of the time,

 

 

horizontal dilution of position (HDOP)1

 

 

Note: All GPS receiver are subject to degradation of position and

 

 

velocity accuracy under the U.S. Department of Defense.

 

 

Position may be degraded.

 

 

DGPS: approx. less than 5 m, 95% of the time

(6)

Tracking Velocity

900 kts

(7)

Position-fixing Time

Warm start: 12 seconds, Cold start: 90 seconds

(8)

Position Update Interval

1 second

(9)

DGPS Data Receiving

RTCM SC-104 Ver 2.1 formatted

 

 

(External DGPS data required for GP-1650F)

3. DISPLAY SECTION

 

(1)

Effective area

115.284.2 mm

(2)

Display pixels

234320 dots

(3)

Position Indication

Latitude/Longitude or Loran C LOP or DECCA LOP

4. PLOTTER

 

(1)

Effective Projection Area

0.125 nm to 2,048 nm (at equatorial area)

(2)

Track Display

Plot interval: by time (0 to 99 min. 59 sec.) or

 

 

by distance (0 to 99.99 nm)

SP - 1

Image 104
Contents Color DGPS/PLOTTER/SOUNDER Color GPS/PLOTTER/SOUNDER 199 About the TFT LCD Do not open the equipmentDo not disassemble or modify the equipment Do not operate the equipment with wet handsTable of Contents Specifications Sounder Setup OptionsDeclaration of Conformity IiiWord to GP-1650DF/1650F Owners FeaturesForeword System Configuration Display UnitThis page is intentionally left blank Operational Overview Display Unit ControlsInserting Mini Chart Card Turning the Power On/OffTurning the power off Display abbreviationsSelecting a display Adjusting Tone and BrilliancePlotter Displays Sounder Displays Menu Operation, Soft KeysPlotter/Sounder Display Normal Sounder Display10 Demo setting screen Demonstration DisplayThis page is intentionally left blank Video Sounder Operation Principle of OperationKHz picture Sounder Display DescriptionNormal sounder display indications, markers Selecting sounder display mode Bottom-zoom displayMarker zoom display Bottom-lock displayPlotter/Sounder Display Dual-frequency DisplayScope display EnterAutomatic Sounder Operation Manual Sounder OperationAdjusting the gain Measuring DepthSelecting display range Range shiftingSuppressing Interference Suppressing Low Level NoiseErasing Weak Echoes White MarkerBackground and echo colors Selecting Picture Advance SpeedSelecting Background and Echo Colors Alarms Interpreting the Display Zero lineFish school echoes Bottom echoSurface noise/Aeration 34 Surface noise/aerationPlotter Displays Presentation ModesNorth-up Course-upSelecting Chart Scale/Range Mini Chart CardsCursor Shifting the DisplayIndices and chart enlargement Remarks on chart displayChart symbols Furuno mini chart cardAid to navigation data Port service icons Nav-Charts cardsComparison of Furuno and Nav-Charts chart cards GPS satellite monitor display Navigation Data DisplayEnlarging an indication Beacon information display How to read the compass displaySteering Display Highway Display How to read the XTE scaleSetting the range of the XTE scale Changing Operation Mode Fifure 3-16 Display setup1 menuNavigation Trip Distance FishingTracking TrackDisplaying Track Stopping/Restarting Plotting of Track Changing Track ColorTrack Plotting Method, Interval Track plotting methodTrack Memory Changing Track Memory CapacityTrack plotting interval Erasing All Track Plotter display MarkEntering Marks Video sounder display Changing Mark AttributesVideo sounder display Small Changing Mark SizeTions Erasing Marks Displaying Track and Mark PointsErasing individual marks/lines Erasing whole marks/linesWaypoints Entering WaypointsEntering waypoints at own ship’s position Entering waypoints at MOB positionWaypoint menu Changing the shape and color of waypoint markChanging waypoint name, comment, proximity alarm radius Entering waypoints by range and bearingEntering waypoints by latitude and longitude position Changing waypoint positionErasing Individual Waypoints Changing Waypoint DataErasing waypoints through the waypoint list Erasing waypoints by the cursorSearching Waypoints Waypoint Mark SizeChanging Waypoint Position on the Plotter Display This page is intentionally left blank Routes Entering RoutesEntering routes through the route list AbcdefConnecting Routes Inserting, Removing WaypointsEntering routes by the cursor Inserting waypoints through the route listInserting waypoints on the plotter display Removing waypoints from routesAlph List WPTCreating Track-based Routes Removing route waypoints from the plotter displayErasing Routes Save icon appearance On the plotter displayThis page is intentionally left blank Navigation Navigating to Quick PointsSelecting quick point entry method Navigating to a single quick pointNavigating to Ports, Port Services Navigating to Waypoints waypoint listFollowing a Route Navigate route waypoints in reverse orderNavigate directly to a route waypoint Navigate along specific leg of routeRestarting navigation Setting speed for ETA calculationSwitching waypoints Cancelling Navigation This page is intentionally left blank Plotter Alarms Audio Alarm On/OffArrival Alarm IntroductionAnchor Watch Alarm XTE Cross Track Error AlarmSpeed Alarm Proximity AlarmAlarm messages and their meanings Alarm InformationAlarm messages Saving Data to Memory Card Formatting Memory Cards10-1 Saving dataError message Loading Data from Memory Card10-2 Data overwriteConfiguration 10-3Track Waypoint/routeThis page is intentionally left blank Chart Setup Options menu Chart Offset menuCustomizing Your Unit 11-1Chart Details menu Chart details menu descriptionDisplay Options menu 11-2Display setup1 menu description 11-3Display SETUP2 menu description 11-411-5 GPS Setup Options menu description11.3 GPS/DGPS/TD Options menu 11-6 Dgps Setup Options menuDgps Setup Options TD Setup menu TD Setup11-7 Displaying Loran C TDsSounder Setup Options menu Sounder Setup Options menu descriptionRange Setup soft key 11-8System Setup soft key System Setup menu description11-9 Echo Offset 200kHz, Echo Offset 50kHzConfiguration menu Setup Nmea Port 1 menu descriptionSetup NMEA/DGPS Port 2 menu description 11-1011-11 UPLOAD/DOWNLOAD Data menuXON/XOFF Download waypoint/route to PC11-12 22 Connection of GP-1650DF/GP-1650F to PCSystem Menu description 11-13System menu This page is intentionally left blank Using C-MAP NT Model 12-2 Example of caution area window12-3 Objects window12-4 13 Plotter displaySetting Chart Setup Options 12-6 20 Depth Info display12-7 21 Memory, I/O test resultsThis page is intentionally left blank Maintenance & Troubleshooting MaintenanceRecommended maintenance program 13-1Replacement of Fuse, Battery Simple TroubleshootingSimple troubleshooting plotter 13-2Error Messages Simple troubleshooting sounderError messages 13-3Diagnostic Tests 13-4Memory, I/O port test TestDisplay test 13-5Keyboard test Clearing Memories 13-6Furuno chart Menu TreeSounder Setup Options Audio Alarm ON, OFF Loran C Chains Decca Chains World Time Geodetic Chart List General GPS ReceiverDisplay Section PlotterCoating Color Index Index-1Index-2 Index-3