Dell UCPM-800 manual Removing and Installing the Shared Perc 8 Card

Page 24

To remove the Shared PERC 8 card:

1.Push down the two release levers at the edge of the Shared PERC 8 card to disengage the card from the storage-controller card holder.

2.Orient the card so that the other end of the card disengages from the storage-controller card holder on the system board.

CAUTION: When removing or replacing the Shared PERC 8 card, hold the card by its edges. Do not handle the card while holding the battery or the heatsink.

Figure 1. Removing and Installing the Shared PERC 8 Card
1.	release lever (2)	2.	storage-controller card holder
3.	storage controller card	4.	battery
5.	heatsink	6.	touch points (2)
7. storage-controller card connector on the		8.	guide pins (2)
	system board

24

Image 24

Contents User’s Guide Page Contents Driver Installation Deploying The Shared Perc 8 CardGetting help Configurations of the Shared Perc 8 card About The Shared Perc 8 CardSpecifications of a Shared Perc 8 card Storage Subsystem Compatibility Matrix at dell.comPage Supported Operating Systems Best Practices For Shared PercRelated Documentation Locating your system Service Tag Contacting DellDocumentation Feedback Shared Perc 8 Card Features Physical Disk Power ManagementConsistency Checks Virtual Disk InitializationPhysical Disk Roaming Background Initialization Of Virtual DisksFull Initialization Of Virtual Disks Fast Initialization Of Virtual DisksUsing Physical Disk Roaming FastPathVirtual Disk Migration Virtual Disk Cache Policies Migrating Virtual Disks If The Target System Is Turned OffMigrating Virtual Disks If The Target System Is Turned On Virtual Disk Write Cache Policies Write-BackConditions Under Which Write-Back Is Employed Write-throughFault Tolerance Physical Disk Write Cache PolicyConditions under which write-through is employed Virtual Disk Read Cache PoliciesSmart Feature Patrol ReadPhysical disk failure detection Physical Disk Hot SwappingShared Perc 8 Card Cache Preservation Battery Transparent Learn Cycle Controller Failover FeatureConfiguring Multipath Support In Windows Configuring Multipath Support In VMWareMultipath Support Multipath support in LinuxInstalling a New Shared Perc 8 Card Deploying The Shared Perc 8 CardReplacing a Shared Perc 8 Card Prerequisites For Removing The Shared Perc 8 Card Removing The Shared Perc 8 CardRemoving and Installing the Shared Perc 8 Card Installing The Shared Perc 8 Card Post-Installation Tasks For Shared Perc 8 CardFirmware installation or update Updating firmwareDriver Installation Installing Or Updating Windows Drivers For Shared Perc Installing Or Updating Linux Drivers For Shared Perc Installing Or Updating VMware Drivers For Shared PercManagement Applications For Shared Perc 8 Card Troubleshooting Shared Perc 8 Card Boots Into Safe ModeGeneral Issues Degraded State Of Virtual DisksShared Perc 8 Card Not Seen In Device Manager Physical disk issues Unable to rebuild a fault tolerant virtual diskShared Perc 8 Cards Fail To Function Physical Disk In Failed StateFatal Error Or Data Corruption Reported Multiple Disks Become InaccessibleRebuilding a Failed Physical Disk Virtual Disk Fails During Rebuild Using a Global Hot Spare Controller cache issuesPhysical disk takes a long time to rebuild Smart Errors Auto Replacement Member Errors Source Disk FailsTarget Disk Fails General Disk FailsHard-Drive Indicator Patterns Hard-Drive IndicatorsGetting help Documentation feedback