NEC 1765, 1700 Series manual Install the LAN Card

Install the LAN Card

Follow these steps to install the LAN card, as shown on the facing page.

Caution! Take the following steps to protect the main controller board while installing the LAN card.

•Hold the board by its edges to avoid touching the connectors or components.

•Do not use magnetic tools when handling the board.

•Wear charge-dissipative straps and work on antistatic surfaces while handling the main controller board.

•Avoid carpets in cool, dry areas where static may build up.

1.Place the main controller board flat on a table so that the LAN card socket and bracket are on top (A).

2.Rotate the LAN card bracket 90 degrees (B).

3.Slide the LAN card onto the main controller board, so that the LAN card plugs into the main controller board and the LAN card panel fits through the main controller board (C).

4.Insert the LAN card screws into the main controller board panel above and below the LAN card panel. Tighten the screws finger-tight. Rotate the LAN card bracket 90 degrees so that it supports the LAN card

(D).

5.Slide the main controller board back into the printer. Make sure the board is positioned between the rails inside the printer (E).

6.Tighten the two screws finger-tight to fasten the main controller board to the rear of the printer (F).

2–6 1765 Network Printer Configuration Guide