I N S T A L L I N G NEC 1765 S O F T W A R E 3

Overview

This chapter describes how to install NEC 1765 Administration and Client software. It contains the following sections.

Using Silentwriter Software with the Silentwriter 1765

NEC 1765 Software

Installing NEC 1765 Software for NetWare

Installing NEC 1765 Software for TCP/IP

Installing NEC 1765 Software for AppleTalk

Using Silentwriter Software with the Silentwriter 1765

This chapter assumes you have already installed the Silentwriter Printing System and drivers as described in Chapter 2, “Using Silentwriter Software,” of the User’s Guide.

The Printer Setup software, which allows you to specify which printer options have been installed, communicates with the Silentwriter through the parallel cable. If you connect your Silentwriter to the network using Ethernet cable please make note of the following.

The Windows PCL 5e Driver

This printer driver cannot sense installed options across the Ethernet. All printer options will be enabled whether they are actually installed or not. To avoid unexpected output, make sure you choose output options that are actually installed.

The Windows PostScript Driver

The PostScript driver assumes that all options have been installed. In order to direct output to specified printer options you must configure the PostScript driver manually using the PostScript printer driver as described in Chapter 2 of the User’s Guide. Be sure to deselect any option that is not installed.

3–1

Page 33
Image 33
NEC 1700 Series, 1765 Using Silentwriter Software with the Silentwriter, Windows PCL 5e Driver, Windows PostScript Driver