Toshiba SD-37VBSB manual One-touch Timer Recording OTR

To Extend the Recording Time

Press REC/OTR repeatedly until the desired time appears on the display.

To stop the OTR Press STOP.

One-touch Timer Recording (OTR)

The one-touch timer recording feature provides a simple and convenient way to make a timed recording.

Note:

If the tape supply has not sufficed for OTR recording, the clock symbol () will blink at the tape-end and then VCR mode will change to DVD mode.

In this case, press TIMER REC to cancel the blink or press EJECT on the DVD/ VCR to remove the cassette tape.

Preparation

•Turn ON the TV and set to the AV input mode.

•Press VCR to select the VCR mode. (The VCR indicator will light.)

1 Load a blank cassette tape with the erase prevention tab intact. (The DVD/VCR will automatically turn on.)

VCR

2 Select the program(e.g.29) you want to record with CH +/– or number buttons.

1~9 : e.g. 5 = press “5”VCR

10~80 : e.g. 29 = press “2” and “9”.

3 If a recording in Long Play mode is intended, press SP/LP to dis- play "LP".

00:00:00￿￿￿LP￿￿￿￿

4 Press REC/OTR twice. The recording will start and stop after 30 minutes. Each additional press of

REC/OTR will increase the record- ing time to a maximum of 6 hours (See table below).

VCR
REC	￿￿￿￿￿

“REC” will keep blinking in the display.

Recording 0:30 1:00 1:30

6:00 5:00 4:00 3:00 2:00

If REC/OTR is pressed once during the recording, the remain- ing time appears on the screen. When pressed again, the re- cording time is extended to the nearest 30-minute￿￿￿or￿￿1￿-hour￿￿interval.

27

2J50101A [EN] P25-32 27 27/2/06, 5:39 PM