Sony CDP-X5000 manual Hookups, To plug in the connector, To detach the connector, Pin assignment

Hookups

pWhen making analog hookups

When connecting an audio cord, be sure to match the color-coded cord to the appropriate jacks on the components: Red (right) to Red and White (left) to White. Be sure to make connections firmly to avoid hum and noise.

CD player	Amplifier
LINE OUT	TUNER CD AUX
	L
L
	R
R
	INPUT

pWhen making digital hookups

Digital hookups allow you to transmit the digital source signal from the CD directly to another component without any deterioration. You can connect the digital outputs to other digital components such as a digital amplifier, D/A converter, DAT, or MD. When you connect a DAT or MD, you can make digital recordings from CDs. Note that you cannot use the fade in or fade out function (page 16) when recording with this connection.

•If you have a digital component with a coaxial digital input connector

Connect the component via the DIGITAL OUT (COAXIAL) connector using the coaxial cable (not supplied).

	CD player
	DIGITAL OUT			Digital component
OPTICAL		COAXIAL	BALANCED	DIGITAL IN
OFF ON		OFF ON	OFF ON	COAXIAL

Getting Started

After making connections, set the DIGITAL OUT OPTICAL switch on the rear to ON. When not using the optical output, set the switch to OFF.

•If you have a digital component (such as an amplifier) with a balanced input connector

Connect the component via the BALANCED connector using a XLR-3-32 cannon connector or equivalent (not supplied). A balanced connection is highly resistant to external noise and often used by professionals in studios and broadcasting stations.

Using a XLR-3-32 cannon connector or equivalent (not supplied)

A B

To plug in the connector

Align parts A and insert the connector firmly.

To detach the connector,

Hold down the lock button B and pull the connector out.

Pin assignment

	IN			OUT	1: GND
					2: HOT
					3: COLD
2	3	1	1	3	2
	CD player				D/A converter, etc.
	DIGITAL OUT					DIGITAL
OPTICAL	COAXIAL			BALANCED		AES/EBU
					IN	OUT
OFF ON	OFF	ON		OFF	ON

After making connections, set the DIGITAL OUT COAXIAL switch on the rear to ON. When not using the coaxial output, set the switch to OFF.

•If you have a digital component with an optical digital input connector

Connect the component via the DIGITAL OUT (OPTICAL) connector using the optical cable (not supplied). Take off the cap and plug in the optical cable.

	CD player
	DIGITAL OUT		Digital component
OPTICAL	COAXIAL	BALANCED	DIGITAL IN
OFF ON	OFF ON	OFF ON	OPTICAL

After making connections, set the DIGITAL OUT BALANCED switch on the rear to ON. When not using the balanced output, set the switch to OFF.

(continued)

5GB