Playing CDs
Recording from CDs Playing CDs
The program remains even after the Program Play ends
When you press (, you can play the same program again.
You can check the total playing time while programming using the remote (Program Edit)
To select a track, press = or + and check the total playing time. Then press PROGRAM to confirm your selection.
Notes
•The total playing time doesn’t appear in the display when it exceeds 100 minutes.
•“FULL” appears in the display when you try to add a track to a program which already contains 24 tracks.
Checking the track order
You can check your program before or after you start playing.
Press CHECK.
Each time you press this button, the display shows the track number in the programmed order. After the last track in the program, the display shows “End” and returns to the original display. If you check the order after you start playing, the display shows only the remaining track numbers.
Changing the track order
You can change your program before you start playing.
To | You need to |
|
|
Erase a track | Press CHECK until the track |
| you don’t want appears in |
| the display, then press |
| CLEAR |
|
|
Erase the last track in the | Press CLEAR. Each time you |
program | press the button, the last |
| track will be cleared. |
|
|
Add tracks to the end of the | Turn ≠ AMS ± until |
program | track number you want to |
| add appears, then press |
| ENTER. |
| When using the remote, |
| press the number button of |
| the tracks to be added |
| (except for |
|
|
Change the whole program | Press p (stop). Create a new |
completely | program following the |
| programming procedure. |
|
|
Recording Your Own Program
You can record the program you’ve created on a tape, DAT or MD. The program can contain up to 24 tracks. By inserting a pause during programming, you can divide the program into two for recording on both sides of a tape.
•
ENTER | ≠ A M S ± |
PLAYMODE· P
•
ENTER | ≠ A M S ± |
PLAYMODE | · | P |
1Create your program (for side A when recording on a tape) while checking the total playing time indicated in the display.
Follow Steps 1 to 4 in “Creating a program on the player” on page 9 or Steps 1 and 2 in “Creating a
program using the remote” on page 10.
The 
indication appears in the display.
2When you record on both sides of the tape, press
P to insert a pause.
The “P” and 
indications appear in the display and the playing time is reset to “0.00.”
When you record on one side of the tape or on a DAT or MD, skip this step and go to Step 4.
A pause is counted as one track
You can program up to 23 tracks when you insert a pause.
3Repeat Step 1 to create the program for side B.
4Start recording on the deck and then press ·on the player.
When you record on both sides of the tape, the player pauses at the end of the program for side A.
5When you record on side B, reverse the tape and press ·or P on the player to resume playing.