Sony CDP-XE300, CDP-XE500, CDP-XE200 manual Precautions

Page 2

WARNING

To prevent fire or shock hazard, do not expose the unit to rain or moisture.

To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.

The laser component in this product is capable of emitting radiation exceeding the limit for Class 1.

This appliance is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT MARKING is located on the rear exterior.

The following caution label is located inside of the unit.

IMPORTANT

If the plug supplied is not suitable for the socket outlets in your home, it should be cut off and an appropriate plug fitted in accordance with the following instructions.

The wires in this mains lead are coloured in accordance with the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. Do not connect either wire to the earth terminal in the plug which is marked by the letter E or by the safety earth symbol Y or coloured green or green-and-yellow.

WARNING

To prevent shock hazard, do not insert the plug cut off from the mains lead into a socket outlet. This plug cannot be used and should be destroyed.

If you are not going to use the player for a long time, be sure to disconnect the player from the wall outlet. To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord.

AC power cord must be changed only at the qualified service shop.

On placement

Place the player in a location with adequate ventilation to prevent heat build-up in the player.

Do not place the player on a soft surface such as a rug that might block the ventilation holes on the bottom.

Do not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock.

On operation

If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the player. Should this occur, the player may not operate properly. In this case, remove the disc and leave the player turned on for about an hour until the moisture evaporates.

On adjusting volume

NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM

A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience.

Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i.e. marked with 2 or @ mark) must be used.

If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station.

Precautions

On safety

Caution — The use of optical instruments with this product will increase eye hazard.

Should any solid object or liquid fall into the cabinet, unplug the player and have it checked by qualified personnel before operating it any further.

On power sources

Before operating the player, check that the operating voltage of the player is identical with your local power supply. The operating voltage is indicated on the nameplate at the rear of the player.

The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off.

Do not turn up the volume while listening to a portion with very low level inputs or no audio signals. If you do, the speakers may be damaged when a peak level portion is played.

On cleaning

Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine.

If you have any questions or problems concerning your player, please consult your nearest Sony dealer.

2EN

Image 2
Contents CDP-XE500 CDP-XE300 CDP-XE200 Precautions Table of Contents Inserting batteries into the remote except for CDP-XE200 UnpackingHooking Up the System OverviewPOC-15 Optical cable not supplied CD player Connecting the AC power cordGetting Started With the label side up Basic OperationsYou need to Display information while playing a disc Using the DisplayPlaying CDs Checking the total number and playing time of the tracksPlaying Tracks Repeatedly When the disc is played Player repeatsTo cancel Repeat Play To locate You need toRepeating the current track Playing in Random Order Shuffle PlayCreating Your Own Program Program Play Creating a program on the playerIf you’ve made a mistake Creating a program using the remote except for CDP-XE200 ZTo cancel Program Play Program remains even after the Program Play endsChecking the track order Recording Your Own ProgramPlaying CDs Recording from CDs Playing CDs Changing the track orderRecording From CDs Fading In or Out Fading out at the specified time Time Fade CDP-XE500 onlyOn handling CDs Adjusting the Recording Level Peak Search CDP-XE500 onlyRecording From CDs Additional Information Not this wayTroubleshooting SpecificationsIndex IndexPrécautions BienvenueLecture de disques compacts Propos de ce manuelPréparation Enregistrement de disques compactsPréparation DéballageRaccordement du système Vue d’ensemblePOC-15 Câble optique non fourni Lecteur de disques compacts Branchement du cordon d’alimentationRemarque Écouteurs Opérations de baseSi vous voulez Vous devez La face imprimée vers le hautInformations affichées pendant la lecture d’un disque Utilisation de la fenêtre d’affichageLecture de disques compacts Vérification de la durée résiduelleLorsque le disque est Lecture de plages répétéePour localiser Vous devez Reproduit enPour annuler la lecture aléatoire Répéter la lecture de la plage en coursCréation d’un programme de lecture sur le lecteur Numéros de plages Durée totale de lecture programmésSauf sur le CDP-XE200 Z Pour Vous devez Vérification de l’ordre des plagesChanger l’ordre des plages Enregistrement de disques compacts Pour annuler le fondu programmé Fondu enchaîné d’entrée et de sortiePour Appuyez sur Fader Vous pouvez déterminer le temps de lecture de votre choixPas de cette façon Remarques sur les disques compactsManipulation des disques compacts Informations complémentaires DépannageSpécifications Indexformations complémentaires Precauciones ¡BienvenidoGrabación a partir de discos compactos Procedimientos inicialesReproducción de discos compactos Información adicionalDescripción general DesembalajeConexión del sistema ConexionesNota Procedimientos inicialesConexión del cable de alimentación POC-15 Cable óptico no suministrado Reproductor deDistancia sólo para CDP- XE500 Z Operaciones básicasPara Es necesario Con la etiqueta hacia arribaVisualización de información mientras se reproduce un CD Uso del visorReproducción de discos compactos Comprobación del tiempo restanteMusic Scan sólo para CDP-XE500 ≠ a M S ± Reproducción repetida de temasPara localizar Es necesario Cuando se reproduce el disco enRepetición del tema actual Para cancelar la reproducción repetidaPara cancelar la reproducción aleatoria Creación de un programa en el reproductorSi ha cometido un error Si comete un errorPara cancelar la reproducción de programa Para cancelar la reproducción del programaCambio del orden de temas Grabación de un programa propioComprobación del orden de los temas Una pausa se contabiliza como un temaGrabación a partir de discos compactos Sólo para CDP-XE500 Aparición y desapariciónGradual del sonido Incorrecto Notas sobre discos compactosUtilización de discos compactos Información adicional Solución de problemasEspecificaciones Indice alfabético Informdice alfabéticoción adicional
Related manuals
Manual 16 pages 53.37 Kb