
Introduction
Identification of controls (continued)
Inserting batteries
1Open the battery compart- ment cover in the direction of the arrow.
Install two “R03/AAA” batteries | 3 | Replace the compartment |
(supplied), paying attention to the | cover. | |
2 polarity diagram in the battery |
|
compartment.
The precautions below should be followed when using batteries in this device:
1.Use only the size and type of batteries specified.
2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re- versed batteries may cause damage to the device. To avoid a potential short circuit, insert the
3.Do not mix different types of batteries together (e.g. Alkaline and
4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)
Remote control basics
•Press POWER to turn the unit on or off.
•Tap CH or
to move through the channels one channel at a time.
•The Direction buttons (▲/▼/B/A) are also used to navigate
•You can directly access specific channels using Direct channel selection buttons.
Illustration of MV13Q41
Operation:
•Aim the remote control at the remote sensor and press control buttons to operate.
•Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5 meters.
Approx. 5 meters
10
5S20101A | 10 | 12/16/04, 4:27 PM |