Toshiba MV13Q41 owner manual Timer recording, Example, Speed as in step Then press Enter

Recording

Timer recording

Timer recording can be programmed on-screen with the remote control. The built-in timer allows automatic unattended recording of up to 8 programs within 1 month.

ENTER

▲/▼/B/ A

MENU

TIMER REC

Timer recording

Preparation:

•Load a cassette tape with the erase prevention tab intact.

•Check the time and date are correct 16 .

Example:

Program a timer recording for 23rd day, channel 125 (Cable TV), 7:00 - 9:30 PM (Tape speed : SLP).

1 Press MENU, then press B or A to select option.

TIMER REC SET
AUTO REPEAT	OFF

Set the start time, end time, channel and tape
5 speed as in step 4.	￿￿		￿￿￿
Then press ENTER.				￿￿￿￿￿￿￿
		￿￿￿￿￿￿			￿￿￿￿￿￿￿
	￿		￿	￿	￿￿￿￿￿￿￿￿￿￿￿￿
Notes:	￿￿￿￿			￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
• Press ▲ to move cursor backward
for correction.
• To record from external source set
the channel to “L”.	￿		￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

// / / MENU

Press ▲ or ▼ to select “TIMER REC SET”, then

6 To set the timer for another program, repeat

2 press A.

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

steps 3 to 5 to set another program.

7 Press TIMER REC. The TIMER REC indicator will light. The Timer is programed, when the programed time is reached, the recording is automatically started.

To cancel timer recording, press

3 Press ▲ or ▼ to select one of the program line, then press ENTER.

4 Press B or A to select the date, then press ▼.

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

TIMER REC button again and TIMER REC indicator will go out.

Notes:

•The VCR section cannot be used while the TIMER REC in- dicator is lit. If you want to use the VCR operation, press TIMER REC to deactivate the timer.

•When the clock is not set, you cannot select “TIMER REC”. In this case, set the clock (see pages 14~16).

•After a power failure or disconnection of the power plug, all programmed recording setting and time display will be lost upon resumption of power. In this case, reset the clock (see pages 14~16) and reprogram any timer recordings.

•If you want to correct the digits while setting, press ▲ or ▼ until the item you want to correct, then press B or A to cor- rect the desired setting.

•If programming is performed without a tape in the unit, or with a tape without an erase prevention tab, the Timer Re- cording is not possible. If a tape without an erase prevention tab is in the unit, the tape will be ejected.

34

5S20101A [E]p32-36 34 12/16/04, 4:28 PM