Toshiba RBC-AMS41E owner manual Correct operating procedures, Procedure for normal operation

Correct operating procedures

Procedure for normal operation

The functions will differ depending on the model and system.

•Follow the steps below before using the remote control system for the very first time or when changing any of the settings.

•After the steps have been followed, operation will commence using the settings established simply by

pushing the button (32).

Preparations

Turn on the ground fault interrupter.

•When the power is turned on, a dividing line appears on the remote controller display.

*For about a minute after the power has been turned

on, on the LCD screen blinks, and there will be no response to the keys of the remote controller even when they are pushed.

Notes

•Do not turn off the ground fault interrupter during the operating season of the remote control system.

•After the remote control system has been shut down for a prolonged period, turn on the ground fault interrupter back on at least 12 hours before its operation is to be started.

Starting operation

1Push the button (32) to start operation.

•The ON lamp lights, and the operation details are displayed on the LCD screen.

2Push the button (34), and select the mode of operation.

•Each time this button is pushed, the operation mode display changes in the sequence shown below.

•Stop pushing the button when the symbol corresponding to the desired mode of operation lights.

AutoHeating

3 Push the button (32) to shut down operation.

•The ON lamp goes off, and the operation details are cleared from the LCD screen. (The frame lines remain displayed.)

•Before operation shuts down, the self-cleaning operation is commenced if the air conditioner was run in the Auto (during cooling), cooling or dry mode for 10 or more minutes.

*For details on the self-cleaning operation, refer to the “Self-cleaning operations” section.

Changing the air speed

1 Push the button (33), and select the desired air speed.

• Each time the button is pushed, the air speed
					G
display changes in the sequence shown below.
					￿￿
• Stop pushing the button when the symbol
corresponding to the desired air speed lights.
	Auto air speed				￿R
				High air speed
					￿￿
					￿U￿
	Low air speed				￿
				Medium air speed
					￿P
* If, during heating, the rooms do not						heat up
					￿	change the
	quickly at the low air speed setting,
	setting to high or medium.
* The auto air speed cannot be selected￿A￿ during fan
	operations.				￿￿￿ ￿d
Changing the temperature
1 Push the TEMP			and
				buttons (49), and
					.
select the desired temperature setting.
• When the		button (49) is pushed,.othe
temperature on the numeric display goes down;
conversely, when the				button (49)	.ois pushed, the

temperature displayed goes up.

•The temperature cannot be set during fan operations.

Fan Cooling Dry

MB FRIGO Grupa d.o.o., Bani 81, 10010 Zagreb, www.toshiba.hr, e-mail: toshiba@mbfrigo.hr

6