Toshiba RD-XV48DTKF 90 EN, TV Aspect Default 169 Wide, Video Out Default Scart RGB

E3NG0FD_EN.book Page 90 Wednesday, January 30, 2008 10:37 AM

Video

1 In stop mode, press [SETUP]. Select “General Setting” using [U \ D], then press [ENTER].

2 Select “Video” using [U \ D], then press [ENTER].

General Setting

Playback

Display

Video

Recording

Clock

Channel

DivX

HDMI

Reset All

3 Select the desired item using [U \ D], then press [ENTER].

1 TV Aspect

2Video Out

4 Refer to 1. and 2. on this page and set the selected item.

5 When you finish with the setting, press [SETUP] to exit.

1. TV Aspect (Default: 16:9 Wide)

You can select the TV aspect ratio to match the formats of what you are playing back with the unit and your TV screen (4:3 standard or 16:9 widescreen TV).

Select the desired setting using [U \ D], then press [ENTER].

TV Aspect

4:3 Letter Box

4:3 Pan & Scan

16:9 Wide

If you have a standard TV:

Select “4:3 Letter Box”, so that black bars appear on the top and bottom of the TV screen when playing back a wide-screen picture. Select “4:3 Pan & Scan” for a full height picture with both sides trimmed when playing back wide-screen picture.

If you have a widescreen TV:

Select “16:9 Wide”.

2. Video Out (Default: SCART (RGB))

This unit is compatible with the Progressive Scan System. The feature provides you with the higher definition images than the traditional output system does. You can enjoy Progressive Scan image by using HDMI OUT or COMPONENT VIDEO OUT. To utilise the Progressive Scan system through the COMPONENT VIDEO OUT, you must set Video Output mode in “Setup” menu by following the steps on right. “SCART (RGB)” is selected as the default.

•When you set the “Video Out” setting, make sure that the AV1 (TV) Scart socket is connected to your TV with Scart cable.

1 Select the desired setting using

[U \ D], then press [ENTER].

Video Out

SCART (RGB)

Component (Progressive)

Component (Interlace)

•If your TV is compatible with progressive scanning (576p/480p), connect the TV to the COMPONENT VIDEO OUT jacks of this unit and select “Component (Progressive)” and set your TV to the progressive scan mode.

•If your TV is not compatible with progressive scan, select “Component (Interlace)” for component connection, or select “SCART (RGB)” for Scart cable connection.

•Refer to pages 20 to 21 for more details.

Only if you select the “Component (Progressive)”, proceed to step 2. If you select “Component (Interlace)” or “SCART (RGB)”, your setting is activated.

2 Use [L \ P] to select “Yes”. Press [ENTER].

Activating progressive scan:

Check your TV has progressive scan

and connect with component video cable.

NOTE:

If there is no picture or picture is distorted after selecting “Yes”,

wait about 15 seconds for autorecovery.

Activate? Yes No

Final confirmation window will appear.

3 Use [U \ D] to select “Yes”. Press [ENTER] within 15 seconds.

Confirm again to use progressive scan.

If picture is good, select “Yes”.

Yes

No

Your setting is activated.

Note

•When changing “Video Out” setting (“SCART (RGB)”, “Component (Interlace)” or “Component (Progressive)”), connect to the corresponding jack on the TV. If the setting is changed, for example, to “SCART (RGB)” while the COMPONENT VIDEO OUT jacks are used to connect to the TV, a distorted video signal may be output.

90 EN