Toshiba 40G300U, 40G30U manual Connecting aft Hdni or DVI Device to the HDN input, Back panel, Hmr

Connecting aft HDNI ® or DVI

device to the HDN] input

The HDM[ input on your TV receives digital audio and uncompressed digital video from an HDM[ source device, or macompressed digital video from a DVI (Digital Visual Interface) source device.

This input is designed to accept HDCP (High- Bandwidth Digital-Content Protection) wogram material in digital form from ElA/CEA-861-D- compliant m consumer electronic devices (such as a set-top box or DVD player with HDM[ or DVI output).

The HDM[ input can accept and display VGA, SVGA, XGA, WXGA, SXGA, 480i (60Hz), 480p (60Hz), 720p (60Hz), 1080i (60Hz) and 1080p (24Hz/60Hz) signal formats. For detailed signal specifications, see page 66.

Supported Audio format: Linear PCM, sampling rate 32/44.1/48 kHz

Note: To connect a PC to the HDMI input, see page 19.

To connect an HDMI device, you will need:

. one HDM[ cable (type A connector) per HDM[ device

-For proper operation, it is recommended that you use an HDMI cable with the HDMI Logo (

H_mr ).

_ To display an 1080i/60Hz signal format, you will need a Category 2 cable. Conventional HDMI/DVI cable may not work properly.

_ HDMI cable transfers both video and audio.

Separate analog audio cables are not required (see illustration).

-See "Setting the HDMI® audio mode" (_,_page 33).

_g_,"]	w backpanel
	I

'°'i__'iControlpanel

HDIVlldevice	_4	_
.....	.....
To view the HDM! device video:
Select the HDM[	1, HDM[ 2, HDM[	3 or HDM[ 4
video input source on the TV.*

,:, Toselect the video input source, press INPUTon the remote control (t:+ page 22). To program the TV remote control to operate other devices, see Chapter 3.

16

To connect a DVI device, you will need:

. one HDMI-to-DV[ adapter cable (HDM[ type A connector) per DV[ device

- Forproper operation, the length of an HDMI- to-DVl adapter cable should not exceed 9.8 ft (3m). The recommended length is 6.6 ft (2m).

. one pair of standard analog audio cables per DVI[ device

-An HDMI-to-DVI adapter cable transfers video only. Separate analog audio cables are required (see illustration).

_ See "Setting the HDMi° audio mode" (r:+page 33).

TV back panel

Note: To ensure that the HDM/ or DVI device is reset

properly, it is recommended that you follow these procedures:

°When turning on your electronic components,

turn en the TV first, and then the HDMI or DVI device.

°When turning offyour electronic components, turn off the HDMI or DVI device first, and then the TV

[1]EIA/CEA-861-D compliance covers the transmission of uncompressed digital video with high-bandwidth digital content protection, which is being standardized for reception of high-definition video signals. Because this is an evolving technology, it is possible that some devices may not operate properly with the TV.

40 46550300U ENASindb 16 2010/,4/16 F@05:48:21