Toshiba Optimize Your Viewing Experience with the 40G300U and Other Flat Panel TVs

Page 60

Selecting the cinemamode

When you view a DVD (3:2 pulldown processed)

from a DVD player connected to the VIDE0 1, VIDEO2, C010rStream liD (component video), or HDNI inputs on the TV. smoother motion can be obtained by setting the Cinema Node to Film.

To set tile Cinema Mode to Film: (available for 480i and 1080i signals)

MENU

I Press O and open tile Picture menu, highlight Picture Settings and press @.

'_ Highlight AdvancePicture Settings and press @.

3In the Cinema M0de field, select Film.

4' To save the new settings, highlight Done and press @.

To revert to the factory defaults, highlight Reset and press @.

To set the Cinema Mode to Video:

Select Videoin step 3 above.

Usingthe ClearFrameTM feature

The new ClearFrame 120 Hz anti-blur technology doubles the frame rate from 60 frames per second to 120 frames per second, virtually eliminating

motion blur without adding flicker or reducing image brightness.

To turn on the ClearFrame:

MENU

IPress O and open tile Picture menu, highlight Picture Settings and press @.

2Highlight Advanced PictureSettings and press @_.

3in the ClearFrame field, select On.

4.To save the new settings, highlight Done and

press @.

To revert to the factory defaults, highlight Reset and press @.

Note:

oIf you select one of the factory-set picture modes (Sports, Standard, Movie or PC)

and then change the ClearFrame setting, the picture mode automatically changes to Preference.

oWhen ClearFrame is set to Off, the Film Stabilization feature will not be available

(grayed out and set to Off).

6O

Usingthe Film Stabilization feature

This feature helps to eliminate video shaking.

To turn on Film Stabilization:

Press MENU0 and open tile Picturemenu, highlight Picture Settings and press @.

Highlight Advanced Picture Settings and press @.

3in the Film Stabilization field, select Smooth.

4To save the new settings, highlight [10neaM press @. To revert to the factory defaults, highlight Reset

and press @. Note:

oIf you select one of the factory-setpicture modes (Sports, Standard, Movie or PC) and then change the Film Stabilization setting, the picture mode automatically changes to Preference.

oWhen ClearFrame is set to Off, Film Stabilization will be grayed out and set to Off automatically.

oWhen slow motion video is present the units will treat any scrolling text as Film and may cause a slight jitter of the scrolling text. Tuning Off the Film Stabilization feature will correct this issue.

UsingCableClear® digital noise reduction

The CableClea¢" digital noise reduction feature

allows you to reduce visible interference in your

TV picture. This may be useful when receiving a

broadcast with a weak signal (especially a Cable channel) or playing a noisy video cassette or disc.

To change the CableClear settings:

Press MENU0 and open the Picture menu, highlight Noise Reduction and press @.

[n the CableClear field, select your desired setting.

Note:

oIf the current input is ANT/CABLE, VIDEO 1, or VIDEO 2, the menu will display the text "Cab/eC/ear" The available selections are

Off, Low, Middle, and H_gh.

o if the current input is ColorStream liD, HDMI 1, HDMI 2, HDMI 3 or HDMI 4, the

menu will display the text "DNR. " The available selections are Off, Low, Middle,

and High. Low, Middle, and High will reduce the noise in varying degrees, from

lowest to highest, respectively/

3To save tile new settings, highlight Done and

press @.

 

 

To revert

to the factory defaults, highlight Reset

and press @.

(continued)

40_46 55G_00U EN-ASindb

60

2010/_/16

q_@ 05:44:21

Image 60
Contents Toshiba Leading InnovationSafety Precautions Tuneinto SafetyDear Customer Please read this manual completely,and keep itImportantSafety instructions AdditionalSafetyPrecautionsInstallation, Care, and Service InstallationIinoeexs odiiin ..............Car8 IllTo Displayyour Lcdtv usinga Waft Choosinga location for your LcdtvTo Display your Lcdtv on the included Pedestal Stand VESAMounting Pattern Removing the Pedestal StandFCCDeclarationof Conformity Comp#anceStatementtPart15 Usingthe remotecontrol Men//layout and navigationFeatures of yournew TV Overview of steps for installing Setting up, and using your new TVTV front and side panel controls and connections Left side panel TV frontControl panel PowerCord TV back panel connectionsTVback Overview of cable types About the connection illustrationsConnectinga VCRand antenna, Cable TV or Camcorder TVbackpanelCoaxial cables StandardA/V cables Standardaudio cablesIf you have a mono VCRArid a sateJJJte receiver To view the DVD playerHD video input source on the TV Antenna channelsConnecting aft Hdni or DVI Device to the HDN input Back panelHmr IiControlpanel HDIVlldeviceRERZA-LINKconnection Playbackdevice REGZA-LIRRDVDplayer,etcConnectinga digital audio system Connectinga personalcomputerPCTo control the audio Connectinga homenetwork ReservedTVback panel Toconnectthe TVto a home Network Instaflingthe remote control batteries Preparing the remote control forRemote control effective range Learning about the remote controJ TheaterWide1/2/3,Full,43HD,Hativeand Do by DoUsin9the remote controlto controlyourother devices NODESELECTswitch to CABLE/SATRemote Control funcUonaJ key chart RecallProgrammingthe remote control to controlyourother devices Remote control codes CurtisMathes001,1105,0119,012,01 1140,1148,053,056,057 Daewoo011,13,015,017,018Setup Main menu JayoutSouud PreferencesSetup/Installation menu layout Navigatingthe menusystemTerrestrial NputInitial Setup Selecting the menulan.quageTOSHIBALogo LED Menn LanguageSetting channel skip Programmingchannelsinto TVschannel memoryProgrammingchannelsautomatically Lahelin9 channels To assign channel labelsTo remove channel labels To delete the custom labelSetting the Hdmj audio mode Viewing the digital signal meterSetting the time zone Reset Factory Defaults To cancel the resetInstallation menu Factory default valuesLabelingthe video input sources Selecting the video input source to viewConnected to the Hdmi input @.Ir labelTuning channels Tuningchannelsusingthe ChanneJ Browser TMFavorites Browser To add a favorite channel/inputElementsof the ChannelBrowserTM Or to select On or OffComin ued SetUngthe ChannelTuningNode Addingand clearing channels anti inputs in the HistoryListTuningto the next programmed channel Tuningto a specific channel programmedor unprogrammedSwitchingbetweentwo channels usingChannelReturn Switchingbetween two channels usingSurfLockTMNatural Sources onlyUsingthe autoaspect ratiofeature TheaterWide2 and 3 onlyNative Got by Dot For VGA, SVGA, RGA, WXGA, SXGAsources onlyUsingthe FREEZEfeature Adjusting the pictureSelecting the picture mode To turn on the auto aspect ratio featureUsing the closed caption mode Base closed captions Adjusting the picture quaIRyCollrill,d Adjusting the audio Usingthe digital audio selectorDigRalCCSetUngs CCSelectorAdjustingthe audio quaIRy Selecting stereo/SAPbroadcastsSeiecUngthe optical audio output format Atsc digital station if availableUsing the Locks menu Enteringthe PiN codeChangingyourPiN code BlockingTV programsand movies by rating V-ChipMovies Lockingchannels Independentrating system for moviesNC-17 Not intended for anyone 17 and under PO-13 material may be inappropriate forUsingthe input lock feature Usingthe GameTimerUsingthe control panel lock feature To cancel the GameTimerUsing the PC settings feature Setting the PC AudioCoiwd Usingthe Media Player Usingthe Media Playerwith USBToselect the AutoStart function Toopenthe Media PlayerViewing photoflies SingleViewSlidesh0w Playing music filesUsinga networkedserver PC Usingthe Media Player with DlraDuringplayback Viewing photofiles with playing musicfiles at same timeViewing movie es DuringplaybackDeviceinformationdisplaySeepage53 Skiptoprevious/nextphotoSeepage52Settingup the networkaddress for the LARport Sorting 0nly USB storage deviceSee PlaybackSetting the sleep timer UsingREGZA-LIRRManual Setup Auto SetupVolume and Mute controls of Audio REGZA-LINRinputsourceselectionReceiver REGZA-LINK Player Control menu functionsFeature Understandingthe last mode memoryfeatureUnderstanding the auto power off DisplayingTV status informationUsingthe advanced picture settings features UsingDynamicContrastUsingthe static gamma feature Selectingthe color temperatureUsingthe ClearFrameTM feature Usingthe Film Stabilization featureUsingCableClear digital noise reduction Selecting the cinemamodeUsingthe advanced audio Settings featuresUsingNPEGnoisereduction Usingthe GameNode featureGeneraltroubleshooting OtherproblemsPicture problems TV stopsrespondingto controlsSoundproblems Remote control problemsChanneltuning problems Closed caption problemsNedia Player problems Network Setup fails AutoSpecifications VIDEO/AUDIO InputAcceptaNe signal formats for PCiN and HDN! terminals PC in signal formatsHdmi signa formats Limited United States Warranty for LCD Televisions LimitedWarrantyfor CommercialUnitsYourResponsibility LimitedCanadianWarranty for ToshibaBrand Flat Panel TelevisionsCritical Applications GeneralProvisions2010/,4/16 7c-054427 4046 55GS001J FNASindb 2010/5/16 Toshibaamericaconsumer TEL 514