Adding channels to the TV's memory
When you press Channel • or •, your TV will stop only on tile channels you program into the TV's channel memory.
Follow the steps below and on the next page to program all active channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and store them into its memory. After the channels are programmed automatically, you can manually add or erase individual channels (see page 31).
To program channels automatically:
1.Press MENU, and then press • or • until the SET UP menu appears.
2.Press • or • until TV/CABLE is highlighted.
3.Press • or • to highlight either TV or CABLE, depending on which you use. If you use an antenna, highlight TV; if you use cable, highlight CABLE.
LANGUAGE | ENGLESH | |
ANT | Z2 | AN_ |
CH PROGRAM |
| |
ADO/ERASE | AOO | |
OU[CK | CONNECT | GUIDE |
4. Press • to select CH PROGRAM.
LANGUAGE | ENGLISH |
ANTI/2 | ANTI |
OUECK CONNECT | GUEDE |
i{
...............................................................i_
5.Press • or • to start channel programming. The TV will automatically cycle through all the TV or Cable channels (depending on which you selected), and store all active channels in the channel memory.
While the TV is cycling through the channels, the message "Programming
6._,,Vhenchannel programming is complete, the message "Completed" appears.
7.Press Channel • or • to view the programmed channels.
Note:
Totune the TVto a channel not programmed if?the channel memory, you must use the Channel Number buttons on the remote control
Channel
Number
MENU
Channel &V
3O