Onkyo DV-CP706 work OK but, Troller don’t?, Functions don’t, Work?, Rihd doesn’t work?

Troubleshooting—Continued

		There are no batteries in the remote controller.		Install new batteries (page 17).
		The batteries are flat.		Replace with new batteries (page 17).
		The batteries are installed incorrectly.		Check the batteries and correct as necessary
				(page 17).
		You’re not pointing the remote controller at		Point the remote controller at the DV-CP706’s
Buttons on the		the DV-CP706’s remote sensor.		remote sensor (page 17).
				Use the remote controller closer to the DV-CP706
DV-CP706 work OK but
		You’re too far away from the DV-CP706.		(page 17). The remote controller has a range of
those on the remote con-
troller don’t?				approximately 16 ft. (5 meters).
		A strong light source is interfering with the		Make sure that the DV-CP706 is not subjected to
				direct sunshine or inverter-type fluorescent lights.
		DV-CP706’s remote sensor.
				Relocate if necessary.
		If the DV-CP706 is installed in a cabinet with		Open the doors, or use a cabinet without colored
		colored glass doors, the remote controller may
				glass.
		not work reliably when the doors are closed.
		The	cable is not connected properly.	Make sure the		cable is connected properly.
The	functions don’t			To use	, you must make an		connection
		The DV-CP706 is not connected with an ana-		and an analog audio connection (RCA) between
work?
		log audio connection.		the DV-CP706 and the AV receiver, even if they are
				connected digitally.
		The HDMI Control setting is set to Off.		Set the HDMI Control setting to On.
		A component in your system does not support		Refer to the component’s instruction manual to see
		CEC.		if it supports CEC.
		A component in your system has HDMI CEC		Refer to the component’s instruction manual and
		control turned off.		turn on HDMI CEC control.
		One of the components in your system does		Refer to the other component’s instruction manual
				to see if it supports CEC and check your connec-
RIHD doesn’t work?		not support CEC or is not connected correctly.
				tions.
		There’s a problem with the HDMI cable that		Try another HDMI cable.
		you’re using.
		The DV-CP706’s settings may be changed by
		disconnecting and connecting the HDMI		Display a video manually on the TV.
		cable.
		An	cable is connected to the DV-CP706.	Disconnect the		cable.

53